Validation of S-parameter Power Cable Joint Model on Two Cable Defect Sections
نویسندگان
چکیده
منابع مشابه
Power Cable Joint Model: Based on Lumped Components and Cascaded Transmission Line Approach
Abstract: Models in high frequency range for underground power cable connections are essential for the interpretation of partial discharge (PD) signals arising e.g. diagnostic techniques. This paper focuses on modeling of power cable joints. A lumped parameter odel and a cascaded transmission line model are proposed based on scattering parameters (S -parameters) measurement on a 10 kV oil-fille...
متن کاملDevelopment of Polymer Packaging for Power Cable
S. Sremac, P. Gladović, M. Đelošević, B. Matić, A. Matić, Faculty of Technical Sciences, University of Novi Sad, Novi Sad, Serbia. This paper discusses the issues of product design and the procedure of developing polymer packaging as one of the most important engineering tasks. For the purpose of packing power cables a polymer packaging has been designed in the form of drum. Packaging and many ...
متن کاملCable Anatomy I: Understanding the Speaker Cable
How big should the conductors be? The required size (or gauge) of the conductors depends on three factors: (1) the load impedance; (2) the length of cable required; and (3) the amount of power loss that can be tolerated. Each of these involves relationships between voltage (volts), resistance (ohms), current (amperes) and power (watts). These relationships are defined with Ohm’s Law. The job of...
متن کاملLong-life Xlpe Insulated Power Cable
Crosslinked polyethylene (XLPE) has become the globally preferred insulation for power cables, both for distribution and transmission system applications. This insulation system provides cost efficiency in operation and procurement, as well as lower environmental and maintenance requirements when compared to older impregnated paper systems. The purpose of this paper is to outline some of the de...
متن کاملPower Cable Protection in Transmission System
Power cable is widely used in Extra High Voltage (EHV), High Voltage (HV) transmission, Medium Voltage (MV) sub-transmission, and MV / Low Voltage (LV) distribution applications. Basically, the protection principles used for cable are similar with the ones for overhead transmission line. However, the inherent characteristics of cables make its fault behavior more complicate than that of transmi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Indonesian Journal of Electrical Engineering and Computer Science
سال: 2018
ISSN: 2502-4760,2502-4752
DOI: 10.11591/ijeecs.v12.i1.pp282-289