Vacuum property of aluminum alloy chamber treated with electropolishing and machining in dry atmosphere.
نویسندگان
چکیده
منابع مشابه
Fuzzy Modeling for Electrical Discharge Machining of Aluminum Alloy
Electrical discharge machining (EDM) is widely used process in the production of mould / dies, aerospace, automobile and electronics industries where intricate complex shapes need to be machined in very hard materials. The selection of the AISI 64430 was made taking into account its wide range of applications in the industrial field: defense, pharmaceutical, aerospace, shipbuilding industries e...
متن کاملProcess capability improvement through DMAIC for aluminum alloy wheel machining
This paper first enlists the generic problems of alloy wheel machining and subsequently details on the process improvement of the identified critical-to-quality machining characteristic of A356 aluminum alloy wheel machining process. The causal factors are traced using the Ishikawa diagram and prioritization of corrective actions is done through process failure modes and effects analysis. Proce...
متن کاملstudy on effective parameters on machining power and presenting the predictive models in machining of en-ac 48000 aluminum alloy
in this research using statistical analysis the effect of machining parameters such as cutting velocity, feed rate, and tool type on machining power (p m ) in machining process of en-ac 48000 aluminum alloy has been studied. a taguchi l 27 standard array has been utilized as the most economical array to evaluate the factors and their interaction. en-ac 48000 alloy is frequently used in automoti...
متن کاملCleaning of Aluminum After Machining with Coolants
Bobbi Roop Advanced Photon Source Argonne National Laboratory Argonne,IL 60439 An x-ray photoemission spectroscopic study was undertaken to compare the cleaning of the Advanced Photon Source (APS) aluminum extrusion storage ring vacuum chambers after machining with and ~thout water soluble coolants. While there was significant contamination left by the coolants, the cleaning process was capable...
متن کاملInvestigation of Adhesive Resistance of Aluminum [1.0]Alloy by Sandblasting and Electrochemical Machining
A novel method for fabricating an adhesive resistance surface is presented. Sandblasting and electrochemical machining were introduced to prepare micro-nano structures on the sample surface. Then, the prepared sample was immersed in a tridecafluoroctyltriethoxysilane ethanol solvent. The surface of the aluminum alloy sample roughened and covered with low-surface-energy chemical groups was exami...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: SHINKU
سال: 1990
ISSN: 0559-8516,1880-9413
DOI: 10.3131/jvsj.33.514