UV-light-induced curing of branched epoxy novolac resin for coatings
نویسندگان
چکیده
منابع مشابه
UV-LED Curing Efficiency of Wood Coatings
Ultraviolet light emitting diodes (UV-LEDs) have attracted great interest in recent years. They can be used to polymerize coatings, such as those used for prefinished wood flooring. In this project, two lamps were compared for their suitability to be used on a wood flooring finishing line: a UV-microwave and a UV-LED lamp. Low heat emission was found for the UV-LED lamp compared to the UV-micro...
متن کاملHardness of composite resin polymerized with different light-curing units
Introduction: The degree of polymerization depends on the type of light-curing unit. The aim of this study was to compare the hardness of composite resin cured by LED and Halogen light curing units. Methods: In this experimental study, 20 cylindrical samples of Tetric Ceram composite were prepared. Half of them were cured with Ultralume 2 LED and the other half with Astralis 7 Halogen light ...
متن کاملPolyol from castor oil and epoxy resin for PU Coatings
Novel reactive polyols were synthesized via modification of castor oil, a renewable agricultural raw material with epoxy resin and triethylamine as a catalyst. This polyol was used for synthesis of polyurethane coating. Coating formulations were developed by reacting polyol with aromatic adduct, aliphatic adduct and castor oil based adduct in different NCO/OH ratio. All coating composition syst...
متن کاملLight curing of dual cure resin cement
266 This is an Open Access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/ by-nc/3.0) which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.
متن کاملCuring depth of composite resin light cured by LED and halogen light-curing units
The purpose of this study was to evaluate the polymerization effectiveness of a composite resin (Z-250) utilizing microhardness testing. In total, 80 samples with thicknesses of 2 and 4 mm were made, which were photoactivated by a conventional halogen light-curing unit, and light-curing units based on LED. The samples were stored in water distilled for 24 h at 37 ° C. The Vickers microhardness ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Express Polymer Letters
سال: 2018
ISSN: 1788-618X
DOI: 10.3144/expresspolymlett.2018.78