UV-Curable Resins Appropriate for UV Nanoimprint
نویسندگان
چکیده
منابع مشابه
Nanoimprint Lithography with UV-Curable Hyperbranched Polymer Nanocomposites
Nano-scale patterns were produced with UV-curable acrylated hyperbranched polymer nanocomposites using nanoimprint lithography with a glass master in a rapid, low-pressure process. The pattern of the glass master was replicated with composites containing up to 25 vol% SiO2 with a shape fidelity better than 98%. Photo-rheology, interferometry and atomic force microscopy were used to analyze them...
متن کاملUV-curable Encapsulants for LED
UV cured epoxy systems represent complementary technology to the established heat cured epoxy systems for coating, adhesion and encapsulation of electronic devices. The UV cured epoxy systems offer significant benefits in terms of fast cure and thus very short production cycle time; low stress and better colour due to room temperature cure; process wise no mix ratio problem or anhydride handlin...
متن کاملSoft UV Nanoimprint Lithography and Its Applications
Large-area nanopatterning technology has demonstrated high potential which can signifi‐ cantly enhance the performance of many devices and products, such as LEDs, solar cells, hard disk drives, laser diodes, display, etc [1]. For example, nano-patterned sapphire substrates (NPSS) and photonic crystals (PhC) have been considered as the most effective approaches to improve the light output effici...
متن کاملRheological Studies of UV - curable Materials
The challenge for studying fast changing systems with rheology such as UV initiated polymerization and crosslinking is multifold. These materials react within seconds and the moduli change over 2 to 3 decades. UV light must irradiate the sample homogeneously over a short time period and fast data acquisition is required to capture the modulus change during the reaction. An option for UV curing,...
متن کاملCan-Printing Process Uses UV-Curable Coating
Approximately 100 billion aluminum cans are produced annually, mainly for the beverage industry. Early technologies for decorating the cans often used solvent-based coatings containing solvents at concentrations of -70% to 75% by volume (Randall 1992). The solvent composition was typically a mixture of aliphatic hydrocarbons, aromatics, ethers, cellosolves, and acetates. Unfortunately, this met...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Photopolymer Science and Technology
سال: 2008
ISSN: 0914-9244,1349-6336
DOI: 10.2494/photopolymer.21.573