Using surface impedance for calculating wakefields in flat geometry
نویسندگان
چکیده
منابع مشابه
On Wakefields With Two-Dimensional Planar Geometry
In order to reach higher acceleration gradients in linear accelerators, it is advantageous to use a higher accelerating RF frequency, which in turn requires smaller accelerating structures. As the structure size becomes smaller, rectangular structures become increasingly interesting because they are easier to construct than cylindrically symmetric ones. [1,2] One drawback of small structures, h...
متن کاملIn Vivo Dosimetry Using a Flat Surface Sun Nuclear Corporation Diode in 60co Beams for Some Radiotherapy Treatments in Ghana
Introduction: One of the useful standard quality assurance techniques in radiation therapy is monitoring entrance doses in in-vivo dosimetry. An overall tolerance limit of 5% of the absorbed radiation dose has been recommended by the International Commission of Radiological Units. The implementation of an in vivo dosimet...
متن کاملNear-wall Wakefields for Optimized Geometry of Ttf 2 Collimator
Wakefields excited in the small aperture collimators may damage the beam. As pointed out by K. Bane and P. Morton the wakefields can be reduced considerably by tapering the steps and using the “step+taper” collimator geometry. The optimisation of this kind of geometry for TTF 2 collimators with different apertures is carried out in the paper. For the optimal geometries the nonlinear near-wall w...
متن کاملFlat Surface Reconstruction Using Sonar
A technique is given for the recovery of planar surfaces using two beam-spread sonar readings. If a single, planar surface gave rise to the two readings, then the method recovers the surface quite accurately. Simulation and experiment demonstrate the effectiveness of the technique and recommend its use in practice. IThis work was supported in part by the Advanced Research Projects agency under ...
متن کاملFocal plane model for flat refractive geometry
Background: Flow visualization techniques such as uPIV and droplet imaging determine the measurement volume by the focal plane. Thus, an understanding of how the focal plane moves in reference to the camera is necessary when planar interfaces are present between the camera and the focal plane. Methods: Using geometric optics, a focus model for a camera imaging through multiple parallel interfac...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Physical Review Special Topics - Accelerators and Beams
سال: 2015
ISSN: 1098-4402
DOI: 10.1103/physrevstab.18.034401