Using P(Pressure)-T(Temperature) Path to Control the Foaming Cell Sizes in Microcellular Injection Molding Process
نویسندگان
چکیده
منابع مشابه
Precision Injection Molding PRECISION PROCESS CONTROL OF INJECTION MOLDING
1 INTRODUCTION The technical requirements of precision injection molded components demand a heightened level of process performance, and with corresponding process monitoring and control technologies. To obtain the desired critical to quality attributes (CTQs) of the molded products, the injection molding process must be consciously designed such that the key process variables (KPVs) are observ...
متن کاملOnline Simulation-Based Process Control for Injection Molding
An online numerical simulation is presented that is capable of predicting state variables such as flow rate, melt temperature, shear rate, and melt viscosity by using real time data from a nozzle pressure sensor. The simulation solves the non-Newtonian nonisothermal polymer flow into multicavity tools while executing rapidly enough for real time process control. Numerical accuracy and stability...
متن کاملPrimary Experimental Study on Microcellular Injection Molding Using Newly-developed Equipment
Microcellular injection molding using supercritical fluid (SCF) as blowing agent attracts more and more interests. There are still many difficulties in microcellular injection molding, such as decreasing equipment cost, controlling cellular morphology, and increasing feasibility. In this work, primary microcellular injection molding experiments were carried out on newly-developed equipment, whi...
متن کاملconsequence analysis of the leakage, ignition and explosion during high pressure sour gas injection process to the oil reservoir
there is no doubt that human being needs to become integrated with industry and industry needs to be progressed, daily. on the other hand, serious events in industrial units specially in oil industries has been shown that such damages and events are industry related ones. the consequence of such events and damages which resulted in chemical and poisoned explosions and loss of life and property ...
Optimization of the injection molding process of Derlin 500 composite using ANOVA and grey relational analysis
Warpage and shrinkage control are important factors in proving the quality of thin-wall parts in injection modeling process. In the present paper, grey relational analysis was used in order to optimize these two parameters in manufacturing plastic bush of articulated garden tractor. The material used in the plastic bush is Derlin 500. The input parameters in the process were selected according ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Polymers
سال: 2021
ISSN: 2073-4360
DOI: 10.3390/polym13111843