Use of Inerter-based Vibration Absorbers for Suppressing Multiple Cable Modes
نویسندگان
چکیده
منابع مشابه
An electromagnetic inerter-based vibration suppression device
This paper describes how an inerter-based device for structural vibration suppression can be realized using an electromagnetic transducer such as a linear motor. When the motor shaft moves, a difference of voltage is generated across the transducer coil. The voltage difference is proportional to the relative velocity between its two terminals. The electromagnetic transducer will exert a force p...
متن کاملSemiactive Control System based on MR Damper for Suppressing Vibration of Stay Cable under Wind Load
This paper investigates the performance of the semiactive control system based on magnetorheological fluid (MR) dampers for suppressing excessive vibration of stay cable installed in cable-stayed bridges under wind load. The cable model is extracted from a 156.3 m long stay cable with high tension. The external wind load is generated from the widely used wind load spectrum such as the Kaimal sp...
متن کاملInerter-based Vibration Suppression Systems for Laterally and Base-Excited Structures
The paper discusses the design and performance of a novel type of passive control system used for suppressing unwanted vibrations in civil engineering structures subjected to both lateral and base excitation. The new control system is inspired by the traditional tuned mass damper (TMD) with the modification that the mass is replaced by an inerter. An inerter has a two-terminal flywheel device c...
متن کاملSweeping piezoelectric patch vibration absorbers
This paper presents a simulation study concerning the low-mid frequencies control of flexural vibration in a lightly damped thin plate, equipped with five time-varying shunted vibration absorbers. The panel is excited by a rain-on-the-roof broad frequency band stationary disturbance. The absorbers are composed of piezoelectric patches connected to time-varying RL shunt circuits. Continuous, swe...
متن کاملVibration suppression of cables using tuned inerter dampers
This paper considers the use of a tuned inerter damper (TID) system for suppressing unwanted cable vibrations. The TID consists of an inerter, a device that exerts a force proportional to relative acceleration, coupled with a parallel spring and damper. It may be thought of as similar to a tuned-mass-damper, but requiring two terminals. As a two terminal device, the performance of the TID is co...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2017
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2017.09.370