“Use of a permanent metal denture base to avoid recurring denture fracture”

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Shear Bond Strength of Acrylic Denture Teeth to PMMA and Polyamide Denture Base Materials

Introduction: Detachment of denture teeth from denture base is one of the most common reasons for costly denture repairs .This study aimed at evaluating the bond strength of an acrylic denture tooth to polyamide injection-molded thermoplastic denture base material compared with three conventional polymethylmethacrylate (PMMA) denture base resins. Materials and Method: A total of 40 acrylic dent...

متن کامل

Effect of denture cleansers on metal ion release and surface roughness of denture base materials.

Chemical disinfectants are usually associated with mechanical methods to remove stains and reduce biofilm formation. This study evaluated the effect of disinfectants on release of metal ions and surface roughness of commercially pure titanium, metal alloys, and heat-polymerized acrylic resin, simulating 180 immersion trials. Disk-shaped specimens were fabricated with commercially pure titanium ...

متن کامل

Evaluation of adhesion of reline resins to the thermoplastic denture base resin for non-metal clasp denture.

This study aimed to evaluate the tensile and transverse bond strength of chairside reline resins (Tokuyama Rebase II, Mild Rebaron LC) to a thermoplastic acrylic resin (Acrytone) used for non metal clasp denture. The results were compared with those of a conventional heat polymerized acrylic resin (Paladent 20) and a thermoplastic polyamide resin (Biotone). The failure sites were examined by sc...

متن کامل

Factors affecting the bond strength of denture base and reline acrylic resins to base metal materials

OBJECTIVE The shear bond strengths of two hard chairside reline resin materials and an auto-polymerizing denture base resin material to cast Ti and a Co-Cr alloy treated using four conditioning methods were investigated. MATERIAL AND METHODS Disk specimens (diameter 10 mm and thickness 2.5 mm) were cast from pure Ti and Co-Cr alloy. The specimens were wet-ground to a final surface finish of 6...

متن کامل

Effect of Mechanical Modification of Acrylic Resin Denture Teeth Bonded to Acrylic Denture Base

Techniques for bonding denture teeth to acrylic resin denture base remains empirical, with little consensus from the literature, among clinicians or among dental laboratories. Despite of this great variation, the data available regarding effectiveness of various methods used are sparse. The study was carried out to compare the effect of different surface treatments of ridge lap area of acrylic ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: International Journal of Medical Science

سال: 2020

ISSN: 2393-9117

DOI: 10.14445/23939117/ijms-v7i6p105