Urethane Acrylates for D2T2 Printing System
نویسندگان
چکیده
منابع مشابه
High-Performance UV-Curable Urethane Acrylates via Deblocking Chemistry
Research in urethane-acrylate UV-curables has shown that these materials have mechanical properties inferior to those of thermoplastic polyurethanes with very similar composition owing to the high cross-link density in UV-curables; in particular, their ultimate extension is low (less than 100%). Past attempts a t increasing the ultimate extension involved compromising the advantages of the UV-c...
متن کاملAcrylates.
ACRYLATES HAVE been around since the 1930s, when Rohm and Haas began mass production of Plexiglas, a clear and resistant glass substitute made of polymerized methacrylate. It is used extensively for windowpanes, airplane canopies, car lights and windshields, streetlamps, and so on. Numerous other acrylates have been synthesized and have found applications in paints and adhesives, dental composi...
متن کاملBuilding An Enterprise Printing System
Cisco Systems has chosen to internally develop an enterprise wide print system that provides access to more than 2000 printers for both Unix and PCs. The requirements for this print system were that it had to be very cheap to construct, highly scalable, easily maintained by a very small staff, fault tolerant, and mission critical reliable. In other words, management essentially wanted everythin...
متن کاملComputer-aided multiple-head 3D printing system for printing of heterogeneous organ/tissue constructs.
Recently, much attention has focused on replacement or/and enhancement of biological tissues via the use of cell-laden hydrogel scaffolds with an architecture that mimics the tissue matrix, and with the desired three-dimensional (3D) external geometry. However, mimicking the heterogeneous tissues that most organs and tissues are formed of is challenging. Although multiple-head 3D printing syste...
متن کاملbioPrint: A Liquid Deposition Printing System for Natural Actuators
This article presents a digital fabrication platform for depositing solution-based natural stimuli-responsive material on a thin flat substrate to create hygromorphic biohybrid films. Bacillus subtilis bacterial spores are deposited in the printing process. The hardware system consists of a progressive cavity pump fluidic dispenser, a numerical control gantry, a cooling fan, a heating bed, an a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Photopolymer Science and Technology
سال: 2004
ISSN: 0914-9244,1349-6336
DOI: 10.2494/photopolymer.17.69