Unsteady natural convection cooling of a water storage tank with an internal gas flue
نویسندگان
چکیده
منابع مشابه
Flue Gas Cooling
When waste heat is not utilized, cooling of flue gases in special cooling chambers becomes necessary, if the dust':'collecting and associated equipment is constructed of metal. The two most common methods of cooling are by dilution with ambient air, and by evaporation of water in the gas stream. Usually, they are combined. Load sharing depends largely on acceptable visibility of stack effluvia ...
متن کاملIncreasing Cooling Towers Heat Capacity by Flue Gas Introduction
In this paper the changes in the heat capacity of cooling towers has been investigated as a result of injecting combustion products of boilers. In the tower, the air is re-heated through mixing with hot flue gas after passing through the heat exchangers. As a result of this process, the draft of the cooling tower is increased. The additional produced draft depends on the ambient temperature and...
متن کاملIncreasing Cooling Towers Heat Capacity by Flue Gas Introduction
In this paper the changes in the heat capacity of cooling towers has been investigated as a result of injecting combustion products of boilers. In the tower, the air is re-heated through mixing with hot flue gas after passing through the heat exchangers. As a result of this process, the draft of the cooling tower is increased. The additional produced draft depends on the ambient temperature and...
متن کاملA Numerical Modeling for Natural Convection Heat Transfer in Porous Media With Generated Internal Heat Sources
In this paper a numerical method is used to study the unsteady state natural convection heat transfer within a confined porous media with uniform internal heat generation. The governing equations based on the Darcy model and Bossiness approximations are solved, using the finite difference Alternating Direction Implicit (ADI) method. The developed program was used to simulate natural convection ...
متن کاملCFD Modelling of an Underground Water Tank Heat Storage System
In this work, CFD is used to simulate the flow in an existing thermal labyrinth located at the basement of a hospital building. This labyrinth is an underground channel equipped with water tanks to increase the thermal mass and reduce the heating and cooling demand of the building. Thermal energy storage in the water tanks is a complex heat transfer phenomena involving turbulent forced convecti...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Thermal Sciences
سال: 2010
ISSN: 1290-0729
DOI: 10.1016/j.ijthermalsci.2009.05.011