Unsteady Hydraulic Force in Mixed-Flow Pump with Volute Casing.
نویسندگان
چکیده
منابع مشابه
Cavitating Vortex Flow Generated by a Stationary Volute Casing and a Rotating Centrifugal Impeller
Three devices for treating contaminated water using a cavitating vortex have been developed and tested. The first device uses stationary twin volute casings to generate cavitating vortices. Observation of the collisions among the opposing counter-rotating vortices revealed that their end portions whirl, that the vortices never collide head-on, and that they eventually separate into several smal...
متن کاملNumerical Simulation of Cavitation in Mixed Flow Pump
The purpose of this study is to investigate the performance and three-dimensional behavior of the flow in a mixed flow pump and the way cavitation phenomenon is affected by different parameters such as fluid temperature, pump speed and flow rate. Computational fluid dynamic software FLUENT 6.3 was utilized to simulate the whole flow field of the pump. RNG k-ε model combined with standard wall f...
متن کاملEnergy Performance and Radial Force of a Mixed-Flow Pump with Symmetrical and Unsymmetrical Tip Clearances
The energy performance and radial force of a mixed flow pump with symmetrical and unsymmetrical tip clearance are investigated in this paper. As the tip clearance increases, the pump head and efficiency both decrease. The center of the radial force on the principal axis is located at the coordinate origin when the tip clearance is symmetrical, and moves to the third quadrant when the tip cleara...
متن کاملHydraulic performance numerical simulation of high specific speed mixed-flow pump based on quasi three-dimensional hydraulic design method
This research adopts the quasi three-dimensional hydraulic design method for the impeller of high specific speed mixed-flow pump to achieve the purpose of verifying the hydraulic design method and improving hydraulic performance. Based on the two families of stream surface theory, the direct problem is completed when the meridional flow field of impeller is obtained by employing iterative calcu...
متن کاملFlow-Force Analysis in a Hydraulic Sliding-Spool Valve
Original scientific paper The necessary forces for the control of a hydraulic sliding-spool valve are normally determined by the stationary axial momentum forces of the oil flow through a valve. These forces increase with an increase in the volume flow and the pressure difference. Because of the limited actuating-force potential of normal electromechanical actuators, the direct actuation of con...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 1997
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.63.3330