Unloading characteristics of anti-plane shear crack in softening materials
نویسندگان
چکیده
منابع مشابه
Plane Strain Deformations of Locking Materials near a Crack Tip
Plane-strain deformations of an isotropic and homogeneous Hookean body containing a crack are studied and it is required that the dilatation everywhere in the body be. greater than or equal to a constant. Following Prager, the region where the dilatation always equals the constant is identified as the locking region. For the case when the deformations of the body are symmetrical about the plane...
متن کاملA Note on Anti-plane Shear for Compressible Materials in Finite Elastostatics
This note gives a necessary and sufficient condition that a compressible, isotropic elastic material should admit non-trivial states of finite anti-plane shear. One of the simplest classes of deformations of solids is that of anti-plane shear, in which each particle of a cylindrical body undergoes a displacement parallel to the generators of the cylinder and independent of the axial position of...
متن کاملPlane-stress Crack-tip Fields for Pressure-sensitive Dilatant Materials
Abstraet--In this paper we present plane-stress crack-tip stress and strain fields for pressure-sensitive dilatant materials. A hydrostatic stress-dependent yield criterion and the normality flow rule are used to account for pressure-sensitive yielding and plastic dilatancy. The material hardening response is specified by a power-law relation. The plane-stress mode I singular fields are found i...
متن کاملShear Localization due to Strain Softening in Side Pressed Cylinders
In this paper, shear localization due to strain softening in sidepressed cylinders, is inverstigated. Shear localization causes formation of macroscopic shear bands which can be obsserved in the metallographic cross-section. In this paper, for the first time a method is presented in which a simple two-slice model is used to study the formation of shear bands. The results obtained form this mode...
متن کاملFurther studies on the characteristics of the T e integral: Plane stress stable crack propagation in ductile materials
Some Characteristic behavior of the T e (Atluri, Nishioka and Nakagaki (1984)) is identi®ed in this paper through an extensive numerical study. T e is a near tip contour integral and has been known to measure the magnitude of singular deformation ®eld at crack tip for arbitrary material models. In this paper, T e is found to behave quite differently for different choices of near tip integral co...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Theoretical and Applied Fracture Mechanics
سال: 1994
ISSN: 0167-8442
DOI: 10.1016/0167-8442(94)90036-1