Uniform Sb2S3 optical coatings by chemical spray method
نویسندگان
چکیده
منابع مشابه
Determination of Optical Properties in Germanium Carbon Coatings Deposited by Plasma Enhanced Chemical Vapor Deposition
In this research, Germanium-carbon coatings were deposited on ZnS substrates by plasma enhanced chemical vapor deposition (PECVD) using GeH4 and CH4 precursors. Optical parameters of the Ge1-xCx coating such as refractive index, Absorption coefficient, extinction coefficient and band gap were measured by the Swanepoel method based on the transmittance spectrum. The results showed that the refra...
متن کاملThermal Spray Coatings
THERMAL SPRAY is a generic term for a group of processes in which metallic, ceramic, cermet, and some polymeric materials in the form of powder, wire, or rod are fed to a torch or gun with which they are heated to near or somewhat above their melting point. The resulting molten or nearly molten droplets of material are accelerated in a gas stream and projected against the surface to be coated (...
متن کاملSb2S3 grown by ultrasonic spray pyrolysis and its application in a hybrid solar cell
Chemical spray pyrolysis (CSP) is a fast wet-chemical deposition method in which an aerosol is guided by carrier gas onto a hot substrate where the decomposition of the precursor chemicals occurs. The aerosol is produced using an ultrasonic oscillator in a bath of precursor solution and guided by compressed air. The use of the ultrasonic CSP resulted in the growth of homogeneous and well-adhere...
متن کاملNovel Thermal Barrier Coatings Produced by Axial Suspension Plasma Spray
Ceramic Thermal Barrier Coatings (TBCs) on superalloy components are being used successfully in land-based gas turbine and aircraft engines. These coatings are generally made by either air plasma spraying (APS) or electron beam physical vapour deposition (EB-PVD). In general, EB-PVD TBCs have superior durability due to the columnar structure, but they are very expensive compared to APS TBCs. EB...
متن کاملBio-ceramic Composite Coatings by Cold Spray Technology
Bioceramics such as hydroxyapatite (HAP) have been conventionally deposited by plasma spray technique. However, due to the inherent high temperature in the plasma, deleterious effects such as evaporation, phase alteration, residual stress, debonding, and gas release etc., commonly occur in these coatings. This paper presents a novel approach to deposit bioceramic coatings at temperatures well b...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Beilstein Journal of Nanotechnology
سال: 2019
ISSN: 2190-4286
DOI: 10.3762/bjnano.10.18