Understanding the Influences of Thermal and Mixture Inhomogeneities on the Auto-Ignition Process in a Controlled Auto-Ignition (CAI) Engine Using LES
نویسندگان
چکیده
منابع مشابه
Imaging and Analysis of Auto-Ignition and Heavy Knock in a Full Bore Optical SI Engine
The work involved a fundamental study of auto-ignition under unusually high knock intensities for an optical spark ignition engine. The single-cylinder research engine adopted included full bore overhead optical access capable of withstanding continuous peak in-cylinder pressures of up to 150bar. A heavy knock was deliberately induced under relatively low loads using inlet air heating and a pri...
متن کاملFlamelet-based modeling of auto-ignition with thermal inhomogeneities for application to HCCI engines
Homogeneous-charge compression ignition (HCCI) engines have been shown to have higher thermal efficiencies and lower NOx and soot emissions than spark ignition engines. However, HCCI engines experience very large heat release rates which can cause too rapid an increase in pressure. One method of reducing the maximum heat release rate is to introduce thermal inhomogeneities, thereby spreading th...
متن کاملPerformance and Emissions of a 4- Cylinder Gasoline Engine with Controlled Auto-Ignition
Advanced combustion modes such as Controlled Auto-Ignition or Homogeneous Charge Compression Ignition have been under much attention due to their ability to reduce both emissions and fuel consumption. Thus, this paper aims at demonstrating the achievement of Controlled Auto-Ignition combustion on a standard 4-cylinder gasoline engine with negative valve overlap (NVO) and analyzing its performan...
متن کاملconsequence analysis of the leakage, ignition and explosion during high pressure sour gas injection process to the oil reservoir
there is no doubt that human being needs to become integrated with industry and industry needs to be progressed, daily. on the other hand, serious events in industrial units specially in oil industries has been shown that such damages and events are industry related ones. the consequence of such events and damages which resulted in chemical and poisoned explosions and loss of life and property ...
Investigation of Auto Ignition Condition under Different Parameters
In this work, the potential of auto-ignition of heavy oil during in-situ combustion (ISC) process was studied. Kinetic studies were carried out using Thermo Gravimetric Analyzer (TGA), Differential Scanning Calorimetry (DSC) and Accelerating Rate Calorimetric (ARC) techniques. Effects of oxygen partial pressure, reservoir pressure and clay on auto ignition condition were investigated on a n...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Oil & Gas Sciences and Technology – Revue d’IFP Energies nouvelles
سال: 2017
ISSN: 1294-4475,1953-8189
DOI: 10.2516/ogst/2017025