Unbalanced Current in Split Brushes
نویسندگان
چکیده
منابع مشابه
Unbalanced lattice switched-current filters
This paper shows how switched-current filters can be derived from passive filters obtained by the unbalancing of doubly terminated LC lattice structures. The process is similar to what would be done for the simulation of more conventional ladder structures, but the use of lattice prototypes allows the realization in an almost physically symmetrical structure. A comparation of sensitivity charac...
متن کاملMixing Analysis of Passive Micromixer with Unbalanced Three-Split Rhombic Sub-Channels
A micromixer with unbalanced three-split rhombic sub-channels was proposed, and analyses of the mixing and flow characteristics of this micromixer were performed in this work. Three-dimensional Navier-Stokes equations in combination with an advection-diffusion model with two working fluids (water and ethanol) were solved for the analysis. The mixing index and pressure drop were evaluated and co...
متن کاملUnbalanced and Minimal Point Equivalent Estimation Second-Order Split-Plot Designs
Restricting the randomization of hard-to-change factors in industrial experiments is often performed by employing a split-plot design structure. From an economic perspective, these designs minimize the experimental cost by reducing the number of resets of the hard-tochange factors. In this paper, unbalanced designs are considered for cases where the subplots are relatively expensive and the exp...
متن کاملAn Effective Rotor Current Controller for Unbalanced Stand-Alone DFIG Systems in the Rotor Reference Frame
This paper presents an effective rotor current controller for variable-speed stand-alone doubly fed induction generator (DFIG) systems feeding an unbalanced three-phase load. The proposed current controller is developed based on proportional plus two resonant regulators, which are tuned at the positive and negative slip frequencies and implemented in the rotor reference frame without decomposin...
متن کاملUnbalanced and over current Fault protection in low voltage DC bus micro grid systems
Unlike traditional AC distribution systems, protection has been challenging for DC systems. Multi-terminal DC power systems do not have the years of practical experience and standards that AC power systems have. Also, the current power electronic devices cannot survive or sustain high magnitude faults. Converters will shut down to protect themselves under faulted conditions. This makes locating...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TANSO
سال: 1965
ISSN: 1884-5495,0371-5345
DOI: 10.7209/tanso.1965.3