Ultrasonic Tests of FSW Joints
نویسندگان
چکیده
منابع مشابه
the washback effect of discretepoint vs. integrative tests on the retention of content in knowledge tests
در این پایان نامه تاثیر دو نوع تست جزیی نگر و کلی نگر بر به یادسپاری محتوا ارزیابی شده که نتایج نشان دهندهکارایی تستهای کلی نگر بیشتر از سایر آزمونها است
15 صفحه اولFatigue Strength Estimation Based on Local Mechanical Properties for Aluminum Alloy FSW Joints
Overall fatigue strengths and hardness distributions of the aluminum alloy similar and dissimilar friction stir welding (FSW) joints were determined. The local fatigue strengths as well as local tensile strengths were also obtained by using small round bar specimens extracted from specific locations, such as the stir zone, heat affected zone, and base metal. It was found from the results that f...
متن کاملA Case Study on the Evaluation of Friction Stir Welds by Ultrasonic Inspection Technique
Friction stir welding (FSW) is an innovative process that has been successfully used in joining aluminum alloys, normally difficult to weld. Important advantages over fusion welding are better retention of baseline material properties, lower residual stresses and excellent mechanical properties. Defects that occur in FSW joints are due to improper tooling or setup. Non-destructive techniques us...
متن کاملUltrasonic phased array inspection of electrofusion joints in polyethylene pipes
The use of plastic as a pipe material for the transport of gas and water has increased over the last few years, attributed to the significant advantages of this material such as corrosion resistance, strengthto-weight ratio, lightness, flexibility and cost. Consequently, these pipes have a long predicted service life. One of the pipes’ joining processes is electrofusion welding. As for all kind...
متن کاملImproving Fatigue Strength of Welded Joints by Ultrasonic Impact Treatment
Enhancement in fatigue performance of welded joints by Ultrasonic Impact Treatment (UIT) was evaluated with large-scale rolled beam and built-up specimens having yield strength of 345 to 760 MPa. Eighteen rolled-beam specimens having welded details at cover plates and transverse stiffeners and eight built-up specimens having only transverse stiffener details were fatigue tested after treating t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Biuletyn Instytutu Spawalnictwa
سال: 2017
ISSN: 0867-583X,2300-1674
DOI: 10.17729/ebis.2017.4/2