Ultrasonic Testing of Magnesium Alloy Using Tungsten Powder Couplant
نویسندگان
چکیده
منابع مشابه
Hot cracking in tungsten inert gas welding of magnesium alloy AZ91D
Plates of 3–5 mm in thickness were extracted from an AZ91D ingot and then butt joints of the plates were produced using tungsten inert gas (TIG) welding method. The TIG arc was also used to deposit welding beads on some of the thin plates. No cracking was found in the butt joints. However, hot cracking was always observed to propagate from the heat affected zone (HAZ) under the welding bead int...
متن کاملMicrostructure and corrosion characteristics of laser-alloyed magnesium alloy AZ91D with Al-Si powder.
Blown-powder laser surface alloying was performed on the magnesium alloy AZ91D with Al-Si alloy powder to improve corrosion resistance. Characterization by scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS) and x-ray diffraction (XRD) analysis revealed that intermetallic compounds (IMCs) of Mg2Si, Al12Mg17 and Al3Mg2 were formed in the matrix of α-Mg and Al solid solutions...
متن کاملSURFACE HARDENING OF TUNGSTEN-BASED HEAVY ALLOY VIA PACK BORONIZING
The boronizing of a tungsten heavy alloy containing Ni and Fe as the major alloying elements were performed in the present study to increase its surface hardening. Pack cementation method was employed as a well-known, successful solid-state process for boronizing. The coating treatment was accomplished at different temperatures of 1000, 1050 and 1100°C for 6 and 9 hours. The formation of tu...
متن کاملAcoustic Characteristics of Fatigued Aluminum Alloy Using Ultrasonic Shear Waves
Cyclic-tension fatigue of aluminum alloy, Al-4Cu-1Mg, was determined by an analysis of diffracted SH and SV waves, passing through the surface and reflecting the bottom of the specimen, respectively. The internal friction of SV waves begins to increase from fatigue damage ratio(=N/Nf) of 0.5. This suggests increase of movable dislocation. From the analysis of SH waves, the logarithmic damping r...
متن کاملUsing the Ultrasonic Nondestructive Methods for Prediction of Mechanical Properties of AISI 4140 Alloy Steel
Achieving the mechanical properties of steels after various manufacturing and heat treatment processes is significant and essential. In production lines, after producing the specific and standard samples, mechanical properties have been measured by destructive processes which cause waste of cost and time. In addition, destructive techniques cannot detect the miniscule changes made in mechanical...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 2020
ISSN: 0514-5163,1880-7488
DOI: 10.2472/jsms.69.910