Ultra-Precision Single-Point Diamond Turning of a Complex Sinusoidal Mesh Surface Using Machining Accuracy Active Control
نویسندگان
چکیده
Single-point diamond turning (SPDT) assisted with slow tool servo (STS) is the most commonly utilized technique in fabrication of optical modules. However, path significantly affects quality machined surface. In order to realize determined machining accuracy effectively, a generation (TPG) method based on active control (MAAC) presented. The relationship between and error studied. Corner radius compensation (CRC) calculation chord residual are detailed. Finally, effectiveness proposed approach verified through simulation cutting experiment complex sinusoidal mesh surface fabrication.
منابع مشابه
Surface Generation in Ultra Precision Single Point Diamond Turning of Aluminum
INTRODUCTION Ultra precision single point diamond turning is a very promising tool based manufacturing technology because of its reliability, productivity and wide range of applications. However, with the reduction in cutting dimensions compared to traditional precision machining, the process physics differs substantially. This is largely because of size effects and increased surface finish exp...
متن کاملOptical Effect of Surface Finish by Single Point Diamond Machining
Although ultraprecision diamond turned optics can have surface roughness down to tens of nanometers or even lower, they may still contain defects due to machining process variations. Diamond turned surfaces have been carefully studied before [3-12]. The previous research however was mainly focused on the causes of the surface texture and one of the main goals of these studies was to improve the...
متن کاملSurface Roughness Modeling in Precision Turning of Aluminium by Polycrystalline Diamond Tool Using Response Surface Methodology
Diamond, because of its high modulus of elasticity, chemical inertness and exceptionally high hardness, is ideal for obtaining fine surface finish and accuracy. Today’s requirement of high precision parts like magnetic memory device, laser equipment, electrostatic copier, printing machine, etc., made of non-ferrous materials, such as aluminum, copper and resin demands very high surface finish. ...
متن کاملDuctile behavior of optical glass in single point diamond turning
Single point diamond turning tests were carried out on a B270 type glass. Submicrometer cutting conditions were applied in order to generate ductile response during single point machining. The profile generated by the rapid removal of the tool tip from the machined surface, analyzed by atomic force microscopy, showed that the brittle-to-ductile transition occurs at a few tenths of micrometers. ...
متن کاملSingle Point Diamond Turning of CVD coated Silicon Carbide
Scratching experiments, using diamond styli and single point diamond tools, were performed to simulate Single Point Diamond Turning (SPDT). The results of these experiments were used to determine if a ductile response is possible, and then to determine the critical depth of cut or penetration depth for the ductile to brittle transition (DBT). The depths of the scratches produced at different lo...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Strojniški vestnik
سال: 2021
ISSN: ['2536-3948', '0039-2480']
DOI: https://doi.org/10.5545/sv-jme.2021.7172