Ultra Low Friction of DLC Coating with Lubricant

Development, Characterization and Simulation of Low-friction Boundary Lubricant Funcationalized Hydrogels for Use as a Low Friction Cartilage

Ultra-low friction of gold nanocrystals on graphene

Recent calculations [Guerra et al, Nature Materials, 9 634 (2010)] have predicted that gold nanocrystals slide on graphite with two radically different friction coefficients depending on their speeds. At low speeds (~μm/sec), nanocrystals on graphite are expected to possess higher friction, consistent with previous studies of thermal diffusion of gold on graphite and on graphene. At high slidin...

Cryogenic friction behavior of PTFE based solid lubricant composites

Solid lubricants used in aerospace applications must provide low friction and a predictable operation life over an extreme range of temperatures, environments and contact conditions. PTFE and PTFE composites have shown favorable tribological performance as solid lubricants. This study evaluates the effect of temperature on the friction coefficient of neat PTFE, a PTFE/ PEEK composite and an exp...

Tribological investigation of diamond-like carbon coated micro-dimpled surface under bovine serum and osteoarthritis oriented synovial fluid

Osteoarthritis-oriented synovial fluid (OASF), i.e., that typical of a patient with osteoarthritis, has different physical and biological characteristics than bovine serum (BS), a lubricant widely used in biotribological investigations. Micro-dimpled and diamond-like carbon- (DLC) coated surfaces are key emerging interfaces for orthopedic implants. In this study, tribological performances of di...

Evaluation of tribological properties of (Ti,Al)CN/DLC composite coatings deposited by cathodic arc method.

In this study, Ti, Al and N doped DLC – referred to here after as “(Ti,Al)CN/DLC composite”- coating and pure diamond-like coating (DLC) were produced by cathodic arc deposition technique and the effects of the coating thickness on their tribological properties were evaluated. The coatings were characterized, using scanning electron microscopy (SEM), atomic force microscopy (AFM), X-ray diffrac...