Ultra-low friction of biodiesel lubricated ta-C coatings
نویسندگان
چکیده
منابع مشابه
Low Friction CrNMPP/TiNDCMS Multilayer Coatings
Transition metal nitrides like CrN and TiN are widely used in automotive applications due to their high hardness and wear resistance. Recently, we showed that a multilayer architecture of CrN and TiN, deposited using the hybrid-high power impulse magnetron sputtering (HIPIMS) and direct current magnetron sputtering (DCMS)-HIPIMS/DCMS deposition technique, results in coatings which indicate not ...
متن کاملLubricated friction between incommensurate substrates
This paper is part of a study of the frictional dynamics of a confined solid lubricant film – modelled as a one-dimensional chain of interacting particles confined between two ideally incommensurate substrates, one of which is driven relative to the other through an attached spring moving at constant velocity. This model system is characterized by three inherent length scales; depending on the ...
متن کاملHigh reflectance ta-C coatings in the extreme ultraviolet.
The extreme ultraviolet (EUV) reflectance of amorphous tetrahedrally coordinated carbon films (ta-C) prepared by filtered cathodic vacuum arc was measured in the 30-188-nm range at near normal incidence. The measured reflectance of films grown with average ion energies in the ~70-140-eV range was significantly larger than the reflectance of a C film grown with average ion energy of ~20 eV and o...
متن کاملStrategies for Manufacturing Ultra Low ESR Ta Capacitors
Leading edge designs for portable electronic devices require capacitors which deliver volumetric efficiency, high reliability, low cost, reduced propensity for ignition, and low Equivalent Series Resistance (ESR). Tantalum capacitors employing a conductive polymer cathode are uniquely capable of providing all of these critical characteristics. Tantalum capacitors have a long track record for un...
متن کاملSelf-lubricating, low-friction, wear-resistant Al-based quasicrystalline coatings
After gas atomization, a quasicrystalline powder based on aluminium was used to prepare a thick coating by high-velocity oxygen-fuel flame torch spraying. This layer was deposited on top of a bond-coat layer on a steel plate. A post-spraying annealing treatment turned the two layers to their stable state, a γ-brass crystal and an icosahedral quasicrystal, respectively. The projection parameters...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tribology International
سال: 2014
ISSN: 0301-679X
DOI: 10.1016/j.triboint.2013.11.002