ULTIMATE STRENGTH OF STIFFENED PLATES SUBJECTED TO BIAXIAL FORCES
نویسندگان
چکیده
منابع مشابه
Buckling strength of uniaxially compressed orthogonally stiffened plates
The bucking strength calculation includes the determination of global buckling strength, the effective plate width and the torsional buckling strength of open section stiffeners. In each calculation the classic strength formula should be modified considering the effect of initial imperfections and residual welding stresses. The calculation method of Det Norske Veritas design rules and the Euroc...
متن کاملFinite element analysis of stiffened plates
The paper presents the development of a new plate/shell stiffener element and the subsequent application in determine frequencies, mode shapes and buckling loads of different stiffened panels. In structural modelling, the plate and the stiffener are treated as separate finite elements where the displacement compatibility transformation takes into account the torsion – flexural coupling in the s...
متن کاملUltimate strength analysis of composite sections under biaxial bending and axial load
A new generic fiber model algorithm is presented that allows for the efficient analysis of arbitrary composite sections under biaxial bending and axial load. The geometry of the cross section is described by multi-nested curvilinear polygons i.e. closed polygons with edges that are straight lines or circular arcs. The polygons may be convex or concave and may contain openings. The stress–strain...
متن کاملCracking of Laminates Subjected to Biaxial Tensile Strains
During the processing of laminar ceramic, biaxial, residual stresses can arise due to differential thermal contraction between unlike layers. A tensile stress can cause pre-existing flaws to extend across the layer and into the adjacent layers and then tunnel until they meet either another crack or a free surface. A previous analysis has shown that for a given residual stress there is a critica...
متن کاملUltimate Load Capacity and Behavior of Thin-Walled Curved-Steel Square Struts, Subjected to Compressive Load
There have been some experimental tests on hollow curved-steel struts with thin-walled square sections, in order to investigate their general behavior, particularly their capacity for bearing differing loads. One set of square tubes are cold-formed into segments of circular arcs with curvature radii, equal to 4000 mm. Different lengths of curved struts are fabricated so as to cover a practical ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Doboku Gakkai Ronbunshu
سال: 1996
ISSN: 0289-7806,1882-7187
DOI: 10.2208/jscej.1996.537_29