Type of dike using C-shaped vertical cylinders
نویسندگان
چکیده
منابع مشابه
Scattering by rings of vertical cylinders
It is 25 years since the publication of “Linton & Evans” [1] on “The interaction of waves with arrays of vertical circular cylinders”; it is their most cited joint work. The paper describes an exact method in which separation of variables and addition theorems are combined, leading to an infinite system of linear algebraic equations. The method itself is much older, and goes back to a paper by ...
متن کاملTunable capillary-induced attraction between vertical cylinders.
Deformation of a fluid interface caused by the presence of objects at the interface can lead to large lateral forces between objects. We explore these fluid-mediated attractive force between partially submerged vertical cylinders. Forces are experimentally measured by slowly separating cylinder pairs and cylinder triplets after capillary rise is initially established for cylinders in contact. F...
متن کاملWave Scattering from Vertical Surface-Piercing Cylinders
This thesis describes new laboratory observations concerning the interaction between a series of steep incident waves and vertical, surface piercing, cylinders. The motivation for the study arose as a result of wave impact damage sustained to the undersides of several concrete gravity-based structures in the northern North Sea. Earlier work, Swan et al., (1997), demonstrated that in the case of...
متن کاملVirtual Dike: multiscale simulation of dike stability
We present a Virtual Dike simulation module developed as a part of a flood Early Warning System (EWS) for the UrbanFlood project. The UrbanFlood EWS is a distributed system that analyzes sensor data received in real-time from flood defenses (dikes, dams, etc.) and simulates dike stability, breaching and flood propagation. The aim of the Virtual Dike module is to develop an advanced multiscale m...
متن کاملAerodynamic loads on cactus-shaped cylinders at low Reynolds numbers
Direct numerical simulations of flow past cactus-shaped cylinders are performed at Reynolds numbers of 20, 100, and 300. The results are contrasted to those from smooth cylinders at the same Reynolds numbers. The cavities in the cactus-shaped cylinders are seen to reduce the forces acting on them. At Reynolds number of 20, the drag is reduced by 22% due to reduction in the viscous forces. At Re...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Physical Review B
سال: 2017
ISSN: 2469-9950,2469-9969
DOI: 10.1103/physrevb.96.180302