Type IV Damage Evaluation for Mod.9Cr-1Mo Steel Welds Based on Microscopic Creep Damage Simulation
نویسندگان
چکیده
منابع مشابه
Measurement of local creep properties in stainless steel welds
A high temperature measurement system for creep deformation based on the digital image correlation (DIC) technique is described. The new system is applied to study the behaviour of a multi-pass welded joint in a high temperature tensile test and a load controlled creep test at 545°C. Spatially resolved tensile properties and time dependent creep deformation properties across a thick section typ...
متن کاملMulti-Damage Detection for Steel Beam Structure
Damage detection has been focused by researchers because of its importance in engineering practices. Therefore, different approaches have been presented to detect damage location in structures. However, the higher the accuracy of methods is required the more complex deliberations. Based on the conventional studies, it was observed that the damage locations and its size are associated with dynam...
متن کاملA Nonlinear Creep-damage Constitutive Model of Mudstone Based on the Fractional Calculus Theory
During the flood development in an oil field, the creep characteristic of mudstone is one of the important factors causing casing damage. In this study, based on the theory of fractional order differential and taking into account the creep damage evolution rules, a fractional nonlinear creep-damage model is proposed to reflect the instantaneous deformation in loading processes and the accelerat...
متن کاملEvaluation of Eurocode damage equivalent factor based on traffic simulation
The Eurocodes provide a simplified fatigue design control through the use of Fatigue Load Model 3 (FLM3) and a damage equivalent factor, λ, which is now widely used. In applying the Eurocode method, the first problem arises when designers try to determine the corresponding fatigue span length, especially for bridge static systems not listed. A second problem is that in case of long bridges, the...
متن کاملNumerical Simulation of Temperature-Dependent, Anisotropic Tertiary Creep Damage
Directionally-solidified (DS) Ni-base superalloys are commonly applied as turbine materials to primarily withstand creep conditions manifested in either marine-, airor landbased gas turbines components. The thrust for increased efficiency of these systems, however, translates into the need for these materials to exhibit considerable strength and temperature resistance. Accurate prediction of cr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 2012
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.78.623