Two-fluid confined flow in a cylinder driven by a rotating end wall
نویسندگان
چکیده
منابع مشابه
Two-fluid confined flow in a cylinder driven by a rotating end wall.
The flow of two immiscible fluids completely filling an enclosed cylinder and driven by the rotation of the bottom end wall is studied numerically. The simulations are in parameter regimes where there is significant advection of angular momentum, i.e., the disk rotation rate is fast compared to the viscous diffusion time. We consider two classes of scenarios. The first consists of cases that ar...
متن کاملAddendum to "Two-fluid confined flow in a cylinder driven by a rotating endwall".
In a recent paper [Phys. Rev. E 85, 016308 (2012)], we reported on numerical simulations of swirling two-phase flows in which for cases where the viscosity of the upper fluid is sufficiently smaller than that of the lower fluid, a small region of reversed flow is present on the interface. In this Brief Report, we show that the reported reversed flow is grid converged and comment further on its ...
متن کاملSymmetry breaking of the flow in a cylinder driven by a rotating end wall
The flow driven by a rotating end wall in a cylindrical container with aspect ratio H/R52.5 is time dependent for Reynolds numbers Re5VR/n.2700. For Reynolds numbers up to 4000 three solution branches have been identified, and we examine a solution on each one. At Re53000, the flow is axisymmetric and time periodic. At Re53500, the flow is quasiperiodic with a low-frequency modulation and suppo...
متن کاملDevelopment of a novel method in TRMC for a Binary Gas Flow Inside a Rotating Cylinder
A new approach to calculate the axially symmetric binary gas flow is proposed Dalton’s law for partial pressures contributed by each species of a binary gas mixture (argon and helium) is incorporated into numerical simulation of rarefied axially symmetric flow inside a rotating cylinder using the time relaxed Monte-Carlo (TRMC) scheme and the direct simulation Monte-Carlo (DSMC) method. The res...
متن کاملEffects of wall suction/blowing on two-dimensional flow past a confined square cylinder
A numerical simulation is conducted to study the laminar flow past a square cylinder confined in a channel (the ratio of side length of the square to channel width is fixed at 1/4) subjected to a locally uniform blowing/suction speed placed at the top and bottom channel walls. Governing equations with boundary conditions are resolved using a finite volume method in pressure-velocity formulation...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Physical Review E
سال: 2012
ISSN: 1539-3755,1550-2376
DOI: 10.1103/physreve.85.016308