Two Body Abrasive Wear of Fe-Al Intermetallic Compounds
نویسندگان
چکیده
منابع مشابه
Two-body and three-body abrasive wear behaviour of polyaryletherketone composites
Single and multipass two-body and three-body abrasive wear behaviour of various polyaryletherketone composites have been carried out by using a pin-on-disc machine and a rubber wheel abrasion test (RWAT) rig. Abrasive wear studies were conducted under different loads and sliding distances. Comparative wear performance of all the composites at different loads shows that specific wear rate (Ko) o...
متن کاملFabrication of Fe-Al Intermetallic Foams via Organic Compounds Assisted Sintering
The influence of the addition of organic compounds, such as palmitic acid and cholesteryl myristate, on the porous structure of Fe-Al intermetallics formation has been investigated in detail in this paper. It was found that additives have a significant effect on the final porosity of the obtained sinters. Formed gaseous products from combustion play the role of the foaming agent during Fe-Al in...
متن کاملTHE EFFECT OF HEAT TREATMENT ON ABRASIVE WEAR RESISTANCE OF Fe-34Cr-4.5C%WT HARDFACING ALLOY
Abstract: Hardfacing is one of the most useful and economical ways to increase the service life of components subjected to abrasive wear. Iron based hardfacing alloys have long been considered as candidate coatings for wear-resistant applications in industry. In the present work two layer of Fe-34Cr-4.5C%wt hardfacing alloy was deposited on ASTM A36 carbon steel plates by SMAW method. The m...
متن کاملRecycling of Corundum Particles - Two-body Abrasive Wear of Polymeric Composites Based on Waste
Original scientific paper Recycling of all materials should be supported by modern society. Material recycling is one of the most important ways of dealing with waste. One of material recycling possibilities is an inclusion of waste into primary matrices. A suitable ratio and a combination of waste particles influence in a positive way mechanical properties of the material in which they are dis...
متن کاملTribological Behaviour of Fe-Al Intermetallic Compound Coated Carbon Tool Steel
The use of Fe-Al intermetallic compound coatings has been investigated in order to improve the tribological behaviour of carbon tool steel. The coatings were formed by a pack cementation process and subsequently diffusion annealing at 900˚C in an argon controlled atmosphere. The optimum diffusion time was selected on the basis of optimum thickness and tribological behaviour. The microstructure...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 2003
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.89.11_1178