منابع مشابه
Cellular Automata Modelling of Micro Abrasive Machining
This paper presents the use of Cellular Automata (CA) for modelling micro abrasive machining. A onedimensional CA was initially used to model the workpiece, as having different heights, to represent the roughness; and the forces from the abrasive grits were modelled to randomly erode the workpiece, as such smoothening out and polishing the surface. The modelling was then extended further to two...
متن کاملNeural Network Modeling of Abrasive Flow Machining
This paper discusses the preliminary development of a neural network-based process monitor and off-line controller for abrasive flow machining of automotive engine intake manifolds. The process is only observable indirectly, yet the time at which machining achieves the specified air flow rate must be estimated accurately. A neural network model is used to estimate when the process has achieved ...
متن کاملAbrasive machining of advanced technical ceramics
The high cost of ceramic components can be associated with complex and time-consuming postmachining, which is currently done by using abrasive machining processes. The IWF and Fraunhofer-IPK are undertaking research activities in the field of abrasive machining which aim at developing and optimizing technologies to expand the application field and to increase productivity of high-performance ma...
متن کاملLiterature Review on Abrasive Jet Machining
A machining operation is basically termed a material removal process, where material is removed in the form of chips. In a machining operation, the output parameter is achieved by controlling various input parameters. This paper discusses the effects of various input parameters in abrasive Jet machining (AJM) on the output parameter(Metal Removal Rate [MRR).This paper presents an extensive revi...
متن کاملAbrasive Flow Machining: Major Research Areas &Analysis
Abrasive flow machining also known as abrasive flow deburring or extrude honing, is an interior surface finishing process characterized by flowing an abrasive-laden fluid through a work piece. This fluid is typically very viscous, having the consistency of putty, or dough. In this paper, the main purpose of the process is to investigate the surface finishing of die steel with the use of abrasiv...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Manufacturing Science and Engineering
سال: 2004
ISSN: 1087-1357,1528-8935
DOI: 10.1115/1.1819313