Tribological behaviour of laser-clad TiCp composite coating
نویسندگان
چکیده
منابع مشابه
PLASTIC DEFORMATION BEHAVIOUR AT THE WORN SURFACE OF NOVEL CAST AL-ALLOY-TICP COMPOSITE
An AI-7wt%Si-5vol%TiCp was worn against a cast iron disc in a tri-pin-on-disc machine, under dry sliding conditions at the sliding speed of 0.24 m/s and applied loads of 6, 20 and 40 N/pin. Stress-strain (`3-^9) curves were constructed by measuring the microhardness and the equivalent strain gradients in near surface regions on the cross-sectional surface prepared parallel to sliding direction....
متن کاملThe tribological properties of Cu-Ni3Al-MoS2 composite coating deposited by magnetron sputtering
In industrial applications, most materials are exposed to wear and friction because multiple conditions are used. However, the tribological properties of these materials can be improved with different techniques. One such technique that improves the frictional property of a surface is the use of self-lubricating coatings. In this study, multicomponent coatings of nominal composition Cu-Ni3Al-Mo...
متن کاملMicrostructure and Tribological Performance of TiB2-NiCr Composite Coating Deposited by APS
Nickel chromium (NiCr) powders with different titanium diboride (TiB2) additions (20, 40 and 60 wt %) were prepared with a mechanical alloying method and then sprayed using an air plasma spraying technology. The microstructure and phase composite of the powders and the cross-sections of deposited coatings were analyzed with a scanning electronic microscope and X-ray diffraction. The tribologica...
متن کاملthe tribological properties of cu-ni3al-mos2 composite coating deposited by magnetron sputtering
in industrial applications, most materials are exposed to wear and friction because multiple conditions are used. however, the tribological properties of these materials can be improved with different techniques. one such technique that improves the frictional property of a surface is the use of self-lubricating coatings. in this study, multicomponent coatings of nominal composition cu-ni3al-mo...
متن کاملApplication of Taguchi Technique to Optimize Tribological Behaviour of Al6061T6/SiC/Al2O3 Metal Matrix Composite
Tribological behaviour of aluminium alloy Al6061T6 reinforced with silicon carbide and alumina oxide particles (10%weight percentage of SiC and Al2O3 particles) fabricated by stir casting process was investigated. The wear and frictional properties of the metal matrix composites was studied by performing dry sliding wear test using a computerized pin-on-disc wear tester. Experiments were conduc...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Wear
سال: 1995
ISSN: 0043-1648
DOI: 10.1016/0043-1648(95)06604-7