Trends for Methane Oxidation at Solid Oxide Fuel Cell Conditions
نویسندگان
چکیده
منابع مشابه
Simulation of a Solid Oxide Fuel Cell with External Steam Methane Reforming and Bypass
Fuel flexibility is a significant advantage of solid oxide fuel cells (SOFCs) and can be attributed to their high operating temperature. The eligibility of a combined heat and power (CHP) system has been investigated as a new power generation methode, in this study. Natural gas fueled SOFC power systems via methane steam reforming (MSR) yield electrical conversion efficiencies exceeding 50% and...
متن کاملEfficiency Analysis of Planar Solid Oxide Fuel Cell at Direct Internal Reforming Conditions
A detailed model is presented for the analysis of temperature, species concentration, and current density profiles as well as the efficiency and power density of a planar solid oxide fuel cell at direct internal reforming condition. The model describes the interactions of mass transport, heat transport, heterogeneous chemistry, and electrochemistry. The heterogeneous chemistry model for the cat...
متن کاملAn octane-fueled solid oxide fuel cell.
There are substantial barriers to the introduction of hydrogen fuel cells for transportation, including the high cost of fuel-cell systems, the current lack of a hydrogen infrastructure, and the relatively low fuel efficiency when using hydrogen produced from hydrocarbons. Here, we describe a solid oxide fuel cell that combines a catalyst layer with a conventional anode, allowing internal refor...
متن کاملIntegrating Multiple Solid Oxide Fuel Cell Modules
Abstract-According to SECA program guidelines, solid oxide fuel cells (SOFC) will be produced in the form of 3–10 kW modules for residential use. In addition to residential use, these modules can also be used in apartment buildings, hospitals, etc., where a higher power rating would be required. For example, a hospital might require a 250 kW power supply. To provide this power using the SOFC mo...
متن کاملCo3O4 spinel protection coating for solid oxide fuel cell interconnect application
In the present study, electrophoretic deposition (EPD) method in different electric fields (30 – 300 V / cm) was used to apply Co3O4 spinel coating to SUS 430 as SOFC interconnect. The coated and uncoated specimens were pre-sintered in air at 800 and 900 °C for 3 h followed by cyclic oxidation at 700 and 800 °C for 500 h, respectively. X-ray diffraction analysis (XRD), Scanning Electron Microsc...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of The Electrochemical Society
سال: 2009
ISSN: 0013-4651
DOI: 10.1149/1.3230622