Transverse mode of an atom laser

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Observation of transverse interference fringes on an atom laser beam.

Using the unique detection properties offered by metastable helium atoms we have produced high resolution images of the transverse spatial profiles of an atom laser beam. We observe fringes on the beam, resulting from quantum mechanical interference between atoms that start from rest at different transverse locations within the outcoupling surface and end up at a later time with different veloc...

متن کامل

Single-transverse-mode Ti:sapphire rib waveguide laser.

Laser operation of Ti:sapphire rib waveguides fabricated using photolithography and ion beam etching in pulsed laser deposited layers is reported. Polarized laser emission was observed at 792.5 nm with an absorbed pump power threshold of 265 mW, which is more than a factor of 2 lower in comparison to their planar counterparts. Measured beam propagation factors M2x and M2y of 1.3 and 1.2, respec...

متن کامل

Model of a two–transverse mode laser with injected signal

We derive a simple model for a two transverse mode laser (that considers the TEM00 and TEM10 modes) in which an injected signal with the shape of the TEM10 mode but a frequency close to that of the TEM00 mode is injected. Here we derive a model for a two–transverse mode laser with injected signal. More specifically, we do consider an incoherently pumped homogeneously broadened laser, in a ring ...

متن کامل

Single transverse-mode laser operation of Ti:sapphire rib waveguides

Ti:sapphire is an attractive laser medium for the development of miniature lasers with widely tunable output (650-1100 nm). However, due to its low peak emission cross section and short fluorescence lifetime, high pump power densities are required to achieve efficient CW lasing. A route to address this problem is to adopt channel waveguide geometries, which are characterized by lower laser thre...

متن کامل

Discontinuous phase elements for transverse mode selection in laser resonators

Discontinuous phase elements can be inserted into laser resonators so that the lasers will operate with only one desired high order transverse mode. These elements introduce sharp discontinuous phase changes so as to result in minimal losses for a desired transverse mode but high losses to others. The basic principles, along with experimental results with Nd:yttrium–aluminum–garnet and CO2 lase...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Physical Review A

سال: 2002

ISSN: 1050-2947,1094-1622

DOI: 10.1103/physreva.65.043615