Transient Thermal Stresses of Angle-Ply Laminated Strip due to Nonuniform Heat Supply in the Width Direction.

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Quasi-Static Transient Thermal Stresses in an Elliptical Plate due to Sectional Heat Supply on the Curved Surfaces over the Upper Face

This paper is an attempt to determine quasi-static thermal stresses in a thin elliptical plate which is subjected to transient temperature on the top face with zero temperature on the lower face and the homogeneous boundary condition of the third kind on the fixed elliptical curved surface. The solution to conductivity equation is elucidated by employing a classical method. The solution of stre...

متن کامل

Mechanical Properties of Angle Ply Laminated Composites- A Review

The purpose of this study is to review many of the available guidelines for Polymer composite materials. Guide lines for failure mode, laminates orientation, winding angle, water absorption, as they strongly influence the mechanical properties of composite materials. The present review is focused on composite laminates made of glass, carbon, graphite, hybrid and natural fiber composites, since ...

متن کامل

Transient Thermal Stresses Analysis in a FPGM Cylinder

The present study aims to investigate the analysis of stress, strain, displacement, and electrical potential of a thick hollow cylinder made of FGPM under mechanical and thermal loads. Distribution of mechanical property of material is considered along the shell stick through the power distribution function. Thermal loads have been taken to signify the difference of temperature between outer an...

متن کامل

Buckling and vibration analysis of angle -ply symmetric laminated composite plates with fully elastic boundaries

The main focus of this paper is on efficiency analysis of two kinds of approximating functions (characteristic orthogonal polynomials and characteristic beam functions) that have been applied in the Rayleigh-Ritz method to determine the non-dimensional buckling and frequency parameters of an angle ply symmetric laminated composite plate with fully elastic boundaries. It has been observed that o...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A

سال: 1999

ISSN: 0387-5008,1884-8338

DOI: 10.1299/kikaia.65.2447