Transient Stability of Three-Phase Reluctance Motors
نویسندگان
چکیده
منابع مشابه
Direct Torque Control of 5-Phase 10/8 Switched Reluctance Motors
A switched Reluctance motor (SRM) has several desirable features, including simple construction, high reliability and low cost. However, it suffers from large torque ripple, highly non-uniform torque output and magnetization characteristics and large noise. Several studies have succeeded in torque ripple reduction for SRM using Direct Torque Control (DTC) technique. DTC method has many adva...
متن کاملDiagnosis of Different Types of Air-Gap Eccentricity Fault in Switched Reluctance Motors Using Transient Finite Element Method
This paper presents a method for diagnosis of eccentricity fault in a switched-reluctance motor (SRM) during offline and standstill modes. In this method, the fault signature is differential induced voltage (DIV) achieved by injecting diagnostic pulses to the motor windings. It will be demonstrated by means of results that there is a correlation between differential induced voltage and eccentri...
متن کاملOptimal design of switched reluctance motors
The fundamental theory of the switched reluctance motor is presented with a number of new equations. It is used to show how the practical development of a design calculation should proceed, and this leads to a discussion of physical characteristics required to achieve satisfactory performance and to reduce acoustic noise. The paper makes a few generic observations on the characteristics of succ...
متن کاملOptimum Design Parameters for Synchronous Reluctance Motors
A series of synchronous reluctance motors (RSM) are analysed using finite element methods. The amount of iron in each rotor is kept the same. It is shown that the saliency ratio is not only dependent on the flux guide reluctance factor but also on the position or span of flux guides. It is also shown that an axially laminated design may not be an optimum configuration due to large number of flu...
متن کاملdiagnosis of different types of air-gap eccentricity fault in switched reluctance motors using transient finite element method
this paper presents a method for diagnosis of eccentricity fault in a switched-reluctance motor (srm) during offline and standstill modes. in this method, the fault signature is differential induced voltage (div) achieved by injecting diagnostic pulses to the motor windings. it will be demonstrated by means of results that there is a correlation between differential induced voltage and eccentri...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEJ Transactions on Power and Energy
سال: 1982
ISSN: 0385-4213,1348-8147
DOI: 10.1541/ieejpes1972.102.634