Transient liquid-phase to guide multiphase evolution in reactive-hot-pressed ZrB2–SiC–ZrC ceramics
نویسندگان
چکیده
منابع مشابه
UV-Vis spectrophotometric analysis and light irradiance through hot-pressed and hot-pressed-veneered glass ceramics.
This study evaluated the irradiance of curing units through core and veneered hot-pressed ceramics as well as the transmittance of these materials. Discs of 0.7, 1.4 and 2 mm in thickness of Empress (EMP) and Empress Esthetic (EST), and 0.8 (n=5) and 1.1 mm (n=5) thickness of Empress 2 (E2) were obtained. For E2, two of the 0.8-mm-thick discs were covered with dentin (1.2- and 1.4-mm-thick) and...
متن کاملStructural and Mechanical Evaluation of Dissimilar Transient Liquid Phase Bonded IN-625 /SS-316L
In the present study, the microstructure and mechanical properties of the dissimilar joint of Inconel 625 (IN-625) superalloy to austenitic stainless steel AISI316L (SS-316L) via AWS-BNi3 interface layer and transient liquid phase (TLP) bonding process were evaluated and necessary conditions for creating an efficient joint were determined. TLP bonding was performed in temperature and time range...
متن کاملStructural and Mechanical Evaluation of Dissimilar Transient Liquid Phase Bonded IN-625 /SS-316L
In the present study, the microstructure and mechanical properties of the dissimilar joint of Inconel 625 (IN-625) superalloy to austenitic stainless steel AISI316L (SS-316L) via AWS-BNi3 interface layer and transient liquid phase (TLP) bonding process were evaluated and necessary conditions for creating an efficient joint were determined. TLP bonding was performed in temperature and time range...
متن کاملApplications of Heat-pressed Ceramics for Single Tooth Restorations
LILIANA POROJAN1, CRISTINA SAVENCU1, SORIN POROJAN2* 1 V. Babes University of Medicine and Pharmacy Timisoara, Faculty of Dentistry, Department of Prostheses Technology, Specialization Dental Technology, 9 Revolutiei 1989 Blvd, Timisoara, Romania 2 V. Babes University of Medicine and Pharmacy Timisoara, Faculty of Dentistry, Department of Oral Rehabilitation, Specialization Dental Technology, 9...
متن کاملMechanical properties and microstructural evolution of vacuum hot-pressed titanium and Ti-6Al-7Nb alloy.
Hot-pressing is a powder metallurgy process where loose powder is loaded into a mould, usually of graphite, and sintered by the simultaneous application of high temperature and pressure. In this study elemental titanium and Ti-6Al-7Nb alloy powders are hot-pressed under different conditions in order to study the influence of the processing parameters on the microstructure and mechanical propert...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Materiomics
سال: 2020
ISSN: 2352-8478
DOI: 10.1016/j.jmat.2020.05.001