Transformation Kinetics on Mechanical Alloying
نویسندگان
چکیده
منابع مشابه
Structural Transformation of Immiscible Metals Induced by Mechanical Alloying
X-ray absorption fine structure(XAFS) is used to investigate the local structural change of Fe60Cu40 and FegoCu20 with the ball milling time. The XAFS results verify that the solid solution of mechanically alloyed Fe-Cu samples are inhomogeneous. We propose that the bcc to fcc structural transformation of Fe small particles of Fe60Cuq0(160h) is induced by interfacial Cu atoms dissolving in smal...
متن کاملEffect of Mechanical Alloying and Sintering on Phase Transformation, Microstructural Evolution, Mechanical Properties and Density of Zr-Cr Alloy
The purpose of present research was production ofZr-based alloy as the nuclear fuel cladding by mechanical alloying (MA) and sintering process. Firstly, Zr and Cr powders were mechanically alloyed to produce the refractory and hard Zr-10 wt% Cr alloy, and then, the powder mixtures were consolidated by press and following sintering at temperature of 800˚C min. The phase evolution, microstructura...
متن کاملAlloying Kinetics in Contact Metallisation for CMOS
Nickel silicides are widely used in making electrical contact to complementary metal-oxidesemiconductor (CMOS) devices in advanced integrated circuits. They have been the preferred contacting material since the 2006 “65 nm technology node”, partly because a self-aligned-silicide (“SALICIDE” [1]) process is available. However, their high temperature behaviour is complex and, crucially, improved ...
متن کاملRaney-nickel Catalysts Produced by Mechanical Alloying
Raney catalysts were prepared by a combination of mechanical alloying and leaching as an alternative in the synthesis of Raney-Nickel catalysts. Binary Al-Ni and ternary Al-Ni-Fe alloys with nominal compositions Al65Ni35, Al75Ni25, Al65Ni30Fe5, Al75Ni20Fe5 (in atomic percent), were processed from pure elemental powders; they consisted mainly of the intermetallic B2 AlNi phase. Aluminum was sele...
متن کاملFe-doped SnO2 obtained by mechanical alloying
In this work, iron-doped SnO2 powders were prepared by two methods: mechanical alloying and mechanochemical alloying with successive thermal treatment. The influence of different milling conditions such as ball to powder weight ratio, milling time, rotation velocity of supporting disc and the type of iron starting reactive and their Fe concentration on the structural and magnetic properties of ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of Physical Chemistry B
سال: 2003
ISSN: 1520-6106,1520-5207
DOI: 10.1021/jp027698i