Transferable tight-binding parameters: An application to Ni and Ni-Al alloys

Oxidation – Nitridation of Ni-Cr-Al Alloys

A series of alloys containing 24-36 wt pct Cr and 13.5 – 25.0 wt pct Al was reacted with air at 1100 °C for 260 h. The products of isothermal reaction were scales of α-Al 2 O 3 plus small amounts of Cr 2 O 3 . These grew according to parabolic kinetics, interrupted by episodic weight losses caused by partial spallation. No nitridation occurred during the isothermal exposures. Reaction during th...

CALCULATION OF THERMODYNAMIC PROPERTIES OF Al-Fe, Al-Ni AND Ni-Fe ALLOYS USING FACTSAGE

Thermodynamic predicting analysis of three binary systems Al-Fe, Al-Ni and Ni-Fe are shown in this paper. Thermodynamic analysis involved calculation of activities, coefficient of activities, partial and integral values for enthalpies and Gibbs energies of mixing and excess energies at three different temperatures: 1873K, 1900K and 1973K, as well as calculated phase diagrams, for the investigat...

Martensitic and Related Transformations in Ni-Al Alloys

The present paper gives a review of results of recent studies investigating the fundamentals of the martensitic and related phase tr-ansformations in Ni-A]. For the former case, the emphasis will be on the microstructure of martensite plates. The latter include the metastable Ni2A1 o-like and stable Ni5A13 bainitic phases. These phases will be discussed in view of their atomic structure, nuclea...

Creep of Ni-Al and Ni-Cr-Al Superalloy Foams

The steady-state creep rate of Ni-base metallic foams, with superalloy composition (in wt. pct) Ni7.8∼9.1Al (relative density, ρ = 2.5-2.6) and Ni-13.5∼16.6Cr-5.1∼8.9Al (ρ = 2.8∼3.0), was measured under a range of temperatures (680∼825°C) and applied stresses (0.1∼0.3 MPa), and compared with that of NiAl intermetallic foams (ρ = 5.3). The stress exponent and activation energy are within the exp...

THE INFLUENCE ON Ni-CONTENT ON THE Ms-TEMPERATURE OF Cu-Zn-Al-Ni ALLOYS