Towards bi-metallic injection molds by directed energy deposition

نویسندگان

چکیده

The throughput of the injection molding process is restricted by cooling time each cycle which accounts for three-fourths time. Manufacturing molds out copper or alloys can reduce because their high thermal conductivity, but mold life reduced has much lower hardness and strength than traditional materials such as steels. By layering steel onto using directed energy deposition, advantages both be exploited to while maintaining durability. In this study, 17-4 PH stainless was deposited a substrate demonstrate potential create multi-material molds.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

An Overview of Additive Manufacturing of Titanium Components by Directed Energy Deposition: Microstructure and Mechanical Properties

The directed energy deposition (DED) process can be employed to build net shape components or prototypes starting from powder or wires, through a layer-by-layer process. This process provides an opportunity to fabricate complex shaped and functionally graded parts that can be utilized in different engineering applications. DED uses a laser as a focused heat source to melt the in-situ delivered ...

متن کامل

A Study of Deposition Coatings Formed by Electroformed Metallic Materials

Major joining methods of dental casting metal include brazing and laser welding. However, brazing cannot be applied for electroformed metals since heat treatment could affect the fit, and, therefore, laser welding is used for such metals. New methods of joining metals that do not impair the characteristics of electroformed metals should be developed. When new coating is performed on the surface...

متن کامل

Injection Compression Molding of Replica Molds for Nanoimprint Lithography

As a breakthrough in the cost and durability of molds for nanoimprint lithography (NIL), replica molds are fabricated by injection compression molding (ICM). ICM is commonly used for optical disks such as DVDs or Blu-ray disks and is also a practical fabrication method for nanostructures. In this paper, I successfully demonstrated the fabrication of cycloolefin polymer replica molds with struct...

متن کامل

Self-administration of metallic mercury by intravenous injection.

sigmoid regions and occasionally in the caecum. It results from pressure necrosis of the colonic wall from impacted faeces. Constipation is the pre-eminent symptom in all cases and straining at stool the precipitating event. Drug-induced faecal impaction is becoming more prevalent and is not uncommon in opiate addicts. Both faecal impaction and perforation have been recently reported in renal t...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Manufacturing letters

سال: 2021

ISSN: ['2213-8463']

DOI: https://doi.org/10.1016/j.mfglet.2021.01.001