Torsional Fracture Properties of Heat-Induced Whey Protein Gels.
نویسندگان
چکیده
منابع مشابه
Effect of pH on Structural Properties of Heat-Induced Whey Protein Gels
Formation and structure of whey protein heat-induced gels (100 mg mL-1) through heat treatment at 80 °C and pH modifications at three pH values of acidic (2), isoelectric (5.6) and neutral (7) were studied. The obtained results indicated that the nature of the primary gel networks was different at each pH value. The heat-induced gels produced at pH of 2 and 7, had acceptab...
متن کاملSurface Properties of Aerated Ion-induced Whey Protein Gels
Aerated whey protein gels were formed using calcium chloride, magnesium chloride or iron (II) chloride induced gelation of pre-denatured protein dispersions. The structure of the obtained gel surface depends on the type and concentration of added salt. Higher cation concentration produced gels a with higher quadratic mean of the surface roughness and maximum roughness height. Aerated gels of op...
متن کاملEnzymatic hydrolysis of heat-induced aggregates of whey protein isolate.
The effects of heat-induced denaturation and subsequent aggregation of whey protein isolate (WPI) solutions on the rate of enzymatic hydrolysis was investigated. Both heated (60 °C, 15 min; 65 °C, 5 and 15 min; 70 °C, 5 and 15 min, 75 °C, 5 and 15 min; 80 °C, 10 min) and unheated WPI solutions (100 g L(-1) protein) were incubated with a commercial proteolytic enzyme preparation, Corolase PP, un...
متن کاملEffect of Calcium Chloride on Rheological Properties and Structure of Inulin - Whey Protein Gels
The rheological properties, structure and potential synergistic interactions of whey proteins (1-6%) and inulin (20%) in mixed gels in the presence of CaCl2 was the aim of this study. Whey proteins have a strong influence on inulin gel formation. At low concentrations (2%) whey proteins did not impair in inulin gel formation. At higher concentration (4%) whey proteins impaired inulin gelation a...
متن کاملFracture energy of gels
To clarify effects of crack speed and cross-link density on fracture energy of acrylamide gels, we evaluated the roughness of the fracture surface and measured the fracture energy taking into account the roughness. The fracture energy increases linearly with crack speed V in a fast crack speed region, and the increasing rate of fracture energy with V decreases with increasing cross-link density...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: NIPPON SHOKUHIN KAGAKU KOGAKU KAISHI
سال: 2001
ISSN: 1341-027X,1881-6681
DOI: 10.3136/nskkk.48.81