منابع مشابه
Relevant Roughness Parameters in Polishing Operations of Previously Milled Surfaces
For time and cost saving reasons, the lowest surface roughness possible is sought in milling operations. High speed milling is recommended in order to minimise the amount of material to be removed in subsequent finishing operations, e.g. grinding, electrical discharge machining or manual polishing. Several roughness parameters are usually employed for the characterization of polished surfaces. ...
متن کاملFriction-corrosion of AISI 316L/bone cement and AISI 316L/PMMA contacts : ionic strength effect on tribological behaviour
Wear phenomena understanding of implants is a challenge: friction-corrosion of biomaterials, which constitute orthopaedic implants, is a significant issue concerning the aseptic loosening. This work aims at studying AISI 316L/bone cement friction which is a tribological problem related to hip joint cemented prostheses. This study focuses on the ionic strength effect on the tribological behaviou...
متن کاملBiomaterial Studies on AISI 316L Stainless Steel after Magnetoelectropolishing
The polarisation characteristics of the electropolishing process in a magnetic field (MEP – magnetoelectropolishing), in comparison with those obtained under standard/conventional process (EP) conditions, have been obtained. The occurrence of an EP plateau has been observed in view of the optimization of MEP process. Up-to-date stainless steel surface studies always indicated some amount of fre...
متن کاملThe Influence of Johnson-Cook Parameters on SPH Modeling of Orthogonal Cutting of AISI 316L
Over the past few decades, there has been a growing interest in modelling of machining processes. In this regard, smoothed particle hydrodynamics (SPH) is one of the latest methods used for that purpose. SPH is a powerful technique that can be used in handling problems of large deformation that are difficult to be tackled using traditional finite element methods. The current work aims to presen...
متن کاملModeling and Optimization of Laser Polishing Process
Laser polishing is a finishing process based on melting material, with the objective of improving surface topography. Some operating parameters must be taken into consideration, such as laser power, feed rate, offset, and overlapping. Moreover, because of its dependence on the primary process, the initial topography has also an impact on the final result. This study describes a quadratic model,...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Mechanics & Industry
سال: 2014
ISSN: 2257-7777,2257-7750
DOI: 10.1051/meca/2014003