Tooth Trace Modification Processing of Helix Gear by Form Grinding Method.
نویسندگان
چکیده
منابع مشابه
Research on Tooth Modification of Spur Bevel Gear
Isometric modification is proposed as a new method of axial modification of spur bevel gear. Based on the gear geometry theory and the normal meshing motion equation of gear pairs, changes of meshing points and angles are analyzed and the effect of axial modification on meshing movement of gear pairs is discussed. After that, a method of drawing spherical involute with the aid of SolidWorks sof...
متن کاملModification Conductivity of Emeraldine Base form of Polyaniline-Cobalt Sulphate Nanocomposite Synthesis by Chemical Method
The structural and electrical properties of polyaniline-cobalt sulphate nanocomposite prepared by chemical method.Polyaniline-cobalt sulphate nanocomposites were synthesized by the cobalt sulphate and ammonium persulphate and aniline.This paper reports on chemical technique using for synthesis of cobalt nanoparticles in the composite bridge is aniline. Electrical conductivity of polyaniline wit...
متن کاملModification Conductivity of Emeraldine Base form of Polyaniline-Cobalt Sulphate Nanocomposite Synthesis by Chemical Method
The structural and electrical properties of polyaniline-cobalt sulphate nanocomposite prepared by chemical method.Polyaniline-cobalt sulphate nanocomposites were synthesized by the cobalt sulphate and ammonium persulphate and aniline.This paper reports on chemical technique using for synthesis of cobalt nanoparticles in the composite bridge is aniline. Electrical conductivity of polyaniline wit...
متن کاملOptimal Modifications of Gear Tooth Surfaces
62 Management Summary In this paper a new method for the introduction of optimal modifications into gear tooth surfaces—based on the optimal corrections of the profile and diameter of the head cutter, and optimal variation of machine tool settings for pinion and gear finishing—is presented. The goal of these tooth modifications is the achievement of a more favorable load distribution and reduce...
متن کاملPerformance analysis of generated hypoid gear based on measured tooth flank form data
Article history: Received 18 February 2013 Received in revised form 19 September 2013 Accepted 22 September 2013 Available online 24 October 2013 A method for predicting and analyzing the tooth contact pattern, vibration, and strength of a generated hypoid gear is needed to achieve a low-noise design and adequate quality control. However, it is not easy to analyze the performance of a generated...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1995
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.61.4088