Tooth Root Bending Stress Analysis of Pre-alloyed Sintered Steel Gears with Different Densities using FEM Model Considering Voids
نویسندگان
چکیده
منابع مشابه
Bending strength simulation of asymmetric involute tooth gears
In order to enhance the load capacity of gears, researchers take notice in the asymmetric tooth gears. Asymmetric gear which has higher pressure angle of back tooth aiming to improve banding strength has been analyzed (Deng, et al., 2003). Brown et al. (Brown, et al., 2010) investigate the asymmetric tooth from both point of view of bending and scuffing. Kruger et al. (Kruger et al., 2013) anal...
متن کاملthe effect of using model essays on the develpment of writing proficiency of iranina pre-intermediate efl learners
abstract the present study was conducted to investigate the effect of using model essays on the development of writing proficiency of iranian pre-intermediate efl learners. to fulfill the purpose of the study, 55 pre- intermediate learners of parsa language institute were chosen by means of administering proficiency test. based on the results of the pretest, two matched groups, one as the expe...
Design, Meshing Characteristics and Stress Analysis of Cylindrical Gears with Curvilinear Tooth Profile
Curvilinear tooth gears are commonly produced on a face milling cutter and a hob cutter. However, this paper proposes a kind of curvilinear tooth gear which is processed by a parallel linkage with a single blade cutter. For the purpose of identifying the meshing and contact characteristics of curvilinear tooth gears, the paper covers the following: (i) equations of tooth surfaces are deduced fr...
متن کاملModal Analysis of Cylindrical Gears with Arcuate Tooth Trace
In this paper, the forming principle, meshing features and tooth surface equation were introduced. And the modal parameters distribution of cylindrical gears with arcuate tooth trace was researched. The results show: 1. The modulus was the biggest impact factor for modal and natural frequency of cylindrical gears with arcuate tooth trace, then tooth width, and the radius of tooth line have the ...
متن کاملInfluence of Addendum Modification Factor on Root Stresses in Normal Contact Ratio Asymmetric Spur Gears
Tooth root crack is considered as one of the crucial causes of failure in the gearing system and it occurs at the tooth root due to an excessive bending stress developed in the root region. The modern power transmission gear drives demand high bending load capacity, increased contact load capacity, low weight, reduced noise and longer life. These subsequent conditions are satisfied by the aid o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 2016
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.63.568