Tooth Fillet Stresses of Gear with Thin Rim : 4th Report, Approximation Formulae for Tooth and Root Stresses of Internal Spur Gear
نویسندگان
چکیده
منابع مشابه
Research on Tooth Modification of Spur Bevel Gear
Isometric modification is proposed as a new method of axial modification of spur bevel gear. Based on the gear geometry theory and the normal meshing motion equation of gear pairs, changes of meshing points and angles are analyzed and the effect of axial modification on meshing movement of gear pairs is discussed. After that, a method of drawing spherical involute with the aid of SolidWorks sof...
متن کاملSpur Gear Tooth Stress Analysis And Stress Reduction
Gears are commonly used for transmitting power. They develop high stress concentration at the root and the point of contact. The repeated stressing on the fillets causes the fatigue failure of gear tooth. The main objective of this study is to add different shaped holes to reduce stress concentration. A finite element model of Spur gear with a segment of three teeth is considered for analysis a...
متن کاملInfluence of Addendum Modification Factor on Root Stresses in Normal Contact Ratio Asymmetric Spur Gears
Tooth root crack is considered as one of the crucial causes of failure in the gearing system and it occurs at the tooth root due to an excessive bending stress developed in the root region. The modern power transmission gear drives demand high bending load capacity, increased contact load capacity, low weight, reduced noise and longer life. These subsequent conditions are satisfied by the aid o...
متن کاملParametric Transition as a Spiral Curve and Its Application in Spur Gear Tooth with FEA
The exploration of this paper will focus on the Cshaped transition curve. This curve is designed by using the concept of circle to circle where one circle lies inside other. The degree of smoothness employed is curvature continuity. The function used in designing the C-curve is Bézier-like cubic function. This function has a low degree, flexible for the interactive design of curves and surfaces...
متن کاملOptimal Modifications of Gear Tooth Surfaces
62 Management Summary In this paper a new method for the introduction of optimal modifications into gear tooth surfaces—based on the optimal corrections of the profile and diameter of the head cutter, and optimal variation of machine tool settings for pinion and gear finishing—is presented. The goal of these tooth modifications is the achievement of a more favorable load distribution and reduce...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1983
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.49.1038