Tool Wear in Machining of Wrought and Cast Aluminium Alloys: Literature Review

Cutting Forces and Tool Wear Investigation for Face Milling of Bimetallic Composite Parts Made of Aluminum and Cast Iron Alloys

Bimetallic parts are used in many industries for weight and cost reduction of workpieces working under high loads and wear. One application for this type of composite material is in automotive industry. In this work the tool wear and cutting forces in the face milling of bimetallic parts made of aluminum and cast iron were investigated. A356 and GG25 alloys that are common materials for bimetal...

Mechanical Behaviour of Commercial Aluminium Wrought Alloys at Low Temperatures

Check Tic-coated Tungsten Carbide Tool Wear in Machining Steel

In industrial production systems, including the most important factors in the economic field machining operations, reduce tool wear due to abrasive nature of the phenomenon on many factors, including temperature Lathe tool, influences, machining conditions (cutting speed, speed losses, forcing to rebuild parts of the manufacturing tolerances disassemble tool wear is caused by the phenomenon, as...

On temperatures and tool wear in machining hypereutectic Al–Si alloys with vortex-tube cooling

This study investigates dry machining of hypereutectic silicon–aluminum alloys assisted with vortex-tube (VT) cooling. The objective is to reduce cutting temperatures and tool wear by enhanced heat dissipation through the chilled air generated by a VT. A machining experiment, cutting mechanics analysis, and temperature simulations are employed to (1) model the heat transfer of a cutting tool sy...

On the Physics of Machining Titanium Alloys: Interactions between Cutting Parameters, Microstructure and Tool Wear

The current work deals with the analysis of mechanisms involved during the machining process of titanium alloys. Two different materials were chosen for the study: Ti-6Al-4V and Ti-55531. The objective was to understand the effect of all cutting parameters on the tool wear behavior and stability of the cutting process. The investigations were focused on the mechanisms of the chip formation proc...