Tool Wear Assessment During Machining of Inconel 718

Temperature Measurement and Numerical Prediction in Machining Inconel 718

Thermal issues are critical when machining Ni-based superalloy components designed for high temperature applications. The low thermal conductivity and extreme strain hardening of this family of materials results in elevated temperatures around the cutting area. This elevated temperature could lead to machining-induced damage such as phase changes and residual stresses, resulting in reduced serv...

Optimization of machining parameters of EDM while machining Inconel 718 for form tolerance and orientation tolerance

This paper demonstrates the effectiveness of optimizing multiple characteristics of electrical discharge machining (EDM) of Inconel 718 using copper electrodes having different shapes via Taguchi method-based Grey analysis. The modified algorithm adopted here is used successfully for both detraining the optimum settings of machining parameters and for combining multiple quality characteristic i...

Investigation of Electric Discharge Machining of Inconel 718 Using Special Graphite Electrode

Electric Discharge Machining is a non-conventional machining process, used to machining difficult to machine materials. The major problem faced while doing EDM is high tool wear rate, end wear, corner wear , surface roughness and low material removal rate,. In this research work experimental investigations have been made to find the machining characteristics of high density ultra fine graphite ...

Detection of anamolous machining damages in Inconel 718 and TI 6–4 by eddy current techniques

Laser-assisted machining of Inconel 718 with carbide and ceramic inserts

The use of high strength materials, like titanium alloys and tool steels, is becoming increasingly common in industry. However, these materials are difficult to machine because they maintain their mechanical properties even at high temperatures. Hence, conventional machining (CM) of these materials is slow and inefficient because only slow cutting speeds can be used. In order to increase produc...