Tool Life Prediction of Ti [C,N] Mixed Alumina Ceramic Cutting Tool Using Gradient Descent Algorithm on Machining Martensitic Stainless Steel
نویسندگان
چکیده
منابع مشابه
the effect of machining parameters on round ceramic tool life in hard turning of steel 1.2436
0
متن کاملMachinability Improvement of 17-4PH Stainless Steel by Cryogenic Cooling
17-4PH stainless steel is a martensitic precipitation hardening stainless steel that provides an outstanding combination of high strength, good corrosion resistance, good mechanical properties, good toughness in both base metal and welds, and short time, low-temperature heat treatments that minimize warpage and scaling. This valuable alloy is widely used in the aerospace, nuclear, chemical, pet...
متن کاملMachinability Improvement of 17-4PH Stainless Steel by Cryogenic Cooling
17-4PH stainless steel is a martensitic precipitation hardening stainless steel that provides an outstanding combination of high strength, good corrosion resistance, good mechanical properties, good toughness in both base metal and welds, and short time, low-temperature heat treatments that minimize warpage and scaling. This valuable alloy is widely used in the aerospace, nuclear, chemical, pet...
متن کاملFatigue Life of Graphite Powder Mixing Electrical Discharge Machining AISI D2 Tool Steel
The present paper deals with the design of experimental work matrices for two groups of experiments by using Response surface methodology (RSM). The first EDM group was dealt with the use of kerosene dielectric alone, while the second was treated by adding the graphite micro powders mixing to dielectric fluid (PMEDM). The total heat flux generated and fatigue lives after EDM and PMEDM models we...
متن کاملA Comparative Study of Tool Life Between Ceramic and CBN Cutting Tools when Machining 52100 Steel and Optimization of Cutting Parameters
This paper describes a comparison of tool life between ceramics and cubic boron nitride (CBN) cutting tools when machining hardened steels using the Taguchi method. An orthogonal design, signal-to-noise ratio (S/N) and analysis of variance (ANOVA) were employed to determine the effective cutting parameters on the tool life. The results indicated that the V was found to be a dominant factor on t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Mechanical Engineering Science and Technology
سال: 2020
ISSN: 2580-0817,2580-2402
DOI: 10.17977/um016v4i22020p144