Tolerance Stack Analysis in Francis Turbine Design
نویسندگان
چکیده
منابع مشابه
A Fatigue Analysis of a Hydraulic Francis Turbine Runner
In this work, the estimation of crack initiation life of a hydraulic Francis turbine runner is presented. The life prediction is based on the local strain approach to predict the initiation life. First, the analysis is carried out in air and in water condition and the runner’s natural frequencies were calculated using the finite element (FE) method. The analysis in air is compared with experime...
متن کاملOptimization of GAMM Francis Turbine Runner
Nowadays, the challenge in hydraulic turbine design is the multi-objective design of turbine runner to reach higher efficiency. The hydraulic performance of a turbine is strictly depends on runner blades shape. The present paper focuses on the application of the multi-objective optimization algorithm to the design of a small Francis turbine runner. The optimization exercise focuses on the effic...
متن کاملTolerance Stack Analysis Methods A Critical Review
This document reviews various ways of performing tolerance stack analyses. This review is limited to assembly criteria which are linear or approximately linear functions of the relevant part dimensions. Beginning with the two extreme cornerstones, namely the arithmetic or worst case tolerance stack and the statistical or RSS tolerance stack method, various compromises or unifying paradigms are ...
متن کاملDetection and analysis of part load and full load instabilities in a real Francis turbine prototype
Francis turbines operate in many cases out of its best efficiency point, in order to regulate their output power according to the instantaneous energy demand of the grid. Therefore, it is of paramount importance to analyse and determine the unstable operating points for these kind of units. In the framework of the HYPERBOLE project (FP7-ENERGY-2013-1; Project number 608532) a large Francis unit...
متن کاملModelling of the Francis turbine runner in power stations. Part II: stress analysis
The second part of this paper presents results of stress analysis of the whole Francis turbine runner at Derbendikan power station by using the Finite Element Method (FEM). Computations were carried out with appropriate boundary and loading conditions for water pressure obtained from CFD analysis. The analysis focuses on stress distribution in the runner blades. It has been found that the maxim...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ITB Journal of Engineering Science
سال: 2010
ISSN: 1978-3051
DOI: 10.5614/itbj.eng.sci.2010.42.1.6