TIME-DOMAIN THEORY OF METAL CAVITY RESONATOR
نویسندگان
چکیده
منابع مشابه
Time-domain Theory of Metal Cavity Resonator
This paper presents a thorough study of the time-domain theory of metal cavity resonators. The completeness of the vector modal functions of a perfectly conducting metal cavity is first proved by symmetric operator theory, and analytic solution for the field distribution inside the cavity excited by an arbitrary source is then obtained in terms of the vector modal functions. The main focus of t...
متن کاملFractional Rectangular Cavity Resonator
Fractional curl operator has been used to derive solutions to the Maxwell equations for fractional rectangular cavity resonator. These solutions to the Maxwell equations may be regarded as fractional dual solutions. Behavior of field lines and surface current density in fractional cavity resonator have been investigated with respect to the fractional parameter. Fractional parameter describes th...
متن کاملTime-Domain Numerical Investigation of Ring Resonator Optical Delay Devices
As the demand for high-speed communication both in wired and in wireless systems increases, the optical fiber communication systems have been developed in such a way that the information transmission capacity through an optical fiber exceeds terabits per second. As the data speed increases, the packet switching network is expected to advance from electronic packet switching to all-optical packe...
متن کاملOptical fiber ring resonator characterization by optical time-domain reflectometry.
A novel method for characterization of optical fiber resonators by an optical time-domain reflectometry (OTDR) technique is reported. This easy-to-use technique yields accurate results for cavity lengths ranging from a few meters to several kilometers. A simple relationship is established between the round-trip cavity loss and the position where the OTDR signal is maximum. The value obtained fo...
متن کاملCavity Resonator Measurements at 90 Ghz
A small 4-cavity assembly designed to operate at W-band was built using OFE copper parts machined by wire and plunge EDM proocesses. The machined pieces were then diffusion bonded together. A cutaway section of one the cavity modules is shown in figure 1. Each of the four cavities approximates a one-half guided wavelength at 90 Ghz of reduced height WR 10 waveguide coupled to full height WR10 w...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Progress In Electromagnetics Research
سال: 2008
ISSN: 1559-8985
DOI: 10.2528/pier07090605