Three-Point Bending of Seven Layer Beams – Theoretical and Experimental Studies
نویسندگان
چکیده
منابع مشابه
Theoretical and Experimental Studies of Upright Perforated Wave Filters
Liu et al. (1987) proposed a theoretical solution for scattering of waves through a permeable dissipation region. On the basis of bulk dissipation of the incident wave energy, this method is extended to evaluate the reflection and transmission coefficients of waves through a wave filter composed of rows of perforated sheets aligned normally to the direction of wave propagation. The results of t...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Experimental Investigations into the Collapse of Simple and Reinforced Thin-Walled Channel Beams under Bending Loads
In this paper, collapse behavior of simple and reinforced thin-walled channel- section beams, subjected to three- point bending, is investigated. Many simple channel- section beams of different geometry and some reinforced ones were tested, and their strengths after collapse were obtained thoroughly. Since the available theories in this area are complicated and little attention has been paid to...
متن کاملQuasi-Static Three-Point Bending of Carbon Fiber Sandwich Beams With Square Honeycomb Cores
Sandwich beams comprising identical face sheets and a square honeycomb core were manufactured from carbon fiber composite sheets. Analytical expressions were derived for four competing collapse mechanisms of simply supported and clamped sandwich beams in three-point bending: core shear, face microbuckling, face wrinkling, and indentation. Selected geometries of sandwich beams were tested to ill...
متن کاملMaterial-point method analysis of bending in elastic beams
The aim of this paper is to test different types of spatial interpolation for the materialpoint method. The interpolations include quadratic elements and cubic splines. A brief introduction to the material-point method is given. Simple liner-elastic problems are tested, including the classical cantilevered beam problem. As shown in the paper, the use of negative shape functions is not consisten...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Archives of Civil Engineering
سال: 2016
ISSN: 1230-2945
DOI: 10.1515/ace-2015-0069