Three-dimensional Developing Turbulent Flow in a Square Duct
نویسندگان
چکیده
منابع مشابه
Characterisation of Marginally Turbulent Square Duct Flow
We have performed direct numerical simulation of fully developed turbulent flow in a straight duct with square cross-section. The main objective of the present study is to determine the minimal requirements for maintaining turbulence in duct flows [1]. A detailed analysis of this limit regime allows to elucidate the dominant mechanisms governing the marginally turbulent state, where the self-su...
متن کاملThree Dimensional Laminar Convection Flow of Radiating Gas over a Backward Facing Step in a Duct
In this study, three-dimensional simulations are presented for laminar forced convection flow of a radiating gas over a backward-facing step in rectangular duct. The fluid is treated as a gray, absorbing, emitting and scattering medium. The three-dimensional Cartesian coordinate system is used to solve the governing equations which are conservations of mass, momentum and energy. These equations...
متن کاملThree-dimensional traveling waves in a square duct.
A nonlinear streamwise traveling-wave solution is obtained by homotopy for square duct flow. For a particular symmetry of the perturbations, this wave comes into existence at about Re(b)=600 (based on half-duct width and bulk speed) for a streamwise wave number alpha=0.85 . The resulting four-vortex mean flow resembles the transitional flow structures observed in previous simulations.
متن کامل3D Simulation of the Effects of the Plasma Actuator on the Unsteady, Turbulent and Developing Flow within a Circular Duct
The objective of current paper is 3D simulation of turbulent, developing flow and unsteady within a circular duct in presence of the body force vector persuaded by Dielectric barrier discharge (DBD) plasma actuator inside the surface of geometry for the first time. This article aims at investigating of applying plasma actuator to control separation with special arrangement of electrodes. For th...
متن کاملTHREE DIMENSIONAL MODELING OF TURBULENT FLOW WITH FREE SURFACE IN MOLD FILLING
In the present study a Finite Difference Method has been developed to model the transient incompressible turbulent free surface fluid flow. A single fluid has been selected for modeling of mold filling and The SOLA VOF 3D technique was modified to increase the accuracy of simulation of filling phenomena for shape castings. For modeling the turbulence phenomena k-e standard model was used. In or...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of JSME
سال: 1984
ISSN: 0021-3764,1881-1426
DOI: 10.1299/jsme1958.27.1438