Three-Dimensional Design Optimization of an Anode-Supported SOFC Using FEM
نویسندگان
چکیده
منابع مشابه
Three-dimensional modeling of transport phenomena in a planar anode-supported solid oxide fuel cell
In this article three dimensional modeling of a planar solid oxide fuel cell (SOFC) was investigated. The main objective was to attain the optimized cell operation. SOFC operation simulation involves a large number of parameters, complicated equations, (mostly partial differential equations), and a sophisticated simulation technique; hence, a finite element method (FEM) multiphysics approach ...
متن کاملoptimization of one stage axial compressor by using quasi-three dimensional design and hybrid genetic algorithm
the main design objective of axial compressor is the efficiency increasing, pressure ratio and weight loss. these three parameters are used as an objective function and they are computed according to adopted design procedures. in this paper, a design method is presented that named quasi-three-dimensional. physical flow conditions are applied to design by some constraints to avoid irrational res...
متن کاملDesign Optimization of Structural Acoustic Problems Using Fem-bem
A design optimization procedure of a noise-vibrationharshness (NVH) problem of a complicated vehicle structure is presented by assuming the acoustic pressure does not affect the structural vibration. The steady-state dynamic behavior of the vehicle is calculated from the frequency response finite element analysis, while the sound pressure level within the acoustic cavity is calculated from the ...
متن کاملdesign of an analog fuzzy logic controller chip
fuzzy logic has been developed over the past three decades into a widely applied techinque in classification and control engineering. today fuzzy logic control is one of the most important applications of fuzzy set theory and specially fuzzy logic. there are two general approachs for using of fuzzy control, software and hardware. integrated circuits as a solution for hardware realization are us...
15 صفحه اولDesign optimization of coronary stents by FEM
Two different designs, A and B, with notable different geometrical parameters, were compared. The S-Stent was simulated to expand from its as cut configuration on a hyperelastic balloon model under physiological deployment pressure (below 18 atm). The numerical simulation results reveal that stent B, at diametric expansion of 3.3mm OD, experiences a 50.5% reduction in plastic strain and 10% les...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ECS Transactions
سال: 2013
ISSN: 1938-6737,1938-5862
DOI: 10.1149/05701.2485ecst