Three-Dimensional Design Method of Overhead Transmission Line Based on BIM Technology
نویسندگان
چکیده
منابع مشابه
Analysis of Planar Microstrip Circuits Using Three-Dimensional Transmission Line Matrix Method
The frequency-dependent characteristics of microstrip planar circuits have been previously analyzed using several full-wave approaches. All those methods directly give characteristic of the circuits frequency by frequency. Computation time becomes important if these planar circuits have to be studied over a very large bandwidth. The transmission line matrix (TLM) method presented in this paper ...
متن کاملEffective Design of a 3×4 Two Dimensional Distributed Amplifier Based on Gate Line Considerations
In this paper two dimensional wave propagation is used for power combining in drain nodes of a distributed amplifier (DA). The proposed two dimensional DA uses an electrical funnel to add the currents of drain nodes. The proposed structure is modified due to gate lines considerations. Total gain improvement is achieved by engineering the characteristic impedance of gate lines and also make appr...
متن کاملUbiquitous Networking Based on Two Dimensional Signal Transmission Technology
In this paper, we introduce the latest results of our two-dimensional communication project. The communication elements that touch the surface of a Two-Dimensional Signal Transmission (2DST) sheet establish the connection being supplied with the power by the 2DST sheet. The system allows free location of the element, and proximity (non-contact) connection is realized stably. The structure of 2D...
متن کاملSubwavelength resolution with three-dimensional isotropic transmission-line lenses
Dispersion, impedance matching and resolution characteristics of an isotropic three-dimensional flat lens (“superlens”) are studied. The lens is based on cubic meshes of interconnected transmission lines and bulk loads. We study a practical realization of the lens, based on the microstrip technology. The dispersion equations that have been previously derived, are verified with full-wave simulat...
متن کاملUsing the Energy Balance Method in Estimation of Overhead Transmission Line Aeolian Vibrations
Original scientific paper This paper considers using the Energy Balance Method for estimation of overhead transmission line Aeolian vibrations. Since the damper’s efficiency strongly depends on its position, the procedure of determining the optimum position of the damper is described. It is observed that the optimal damper position depends on the span length also and that the best results can b...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Earth and Environmental Science
سال: 2021
ISSN: 1755-1307,1755-1315
DOI: 10.1088/1755-1315/719/2/022001