Thickness Measurement by Using Cepstrum Ultrasonic Signal Processing

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Fragmentation measurement using image processing

In this research, first of all, the existing problems in fragmentation measurement are reviewed for the sake of its fast and reliable evaluation. Then, the available methods used for evaluation of blast results are mentioned. The produced errors especially in recognizing the rock fragments in computer-aided methods, and also, the importance of determination of their sizes in the image analysis ...

متن کامل

Cross-Correlation by Single-bit Signal Processing for Ultrasonic Distance Measurement

Ultrasonic distance measurement using the pulse-echo method is based on the determination of the time of flight of ultrasonic waves. The pulse-compression technique, in which the cross-correlation function of a detected ultrasonic wave and a transmitted ultrasonic wave is obtained, is the conventional method used for improving the resolution of distance measurement. However, the calculation of ...

متن کامل

Linear Signal Processing and Ultrasonic Transversal Filters

The role of linear transversal filters in signal processing is discussed in Section I. Linear filters for signal processing must often have complicated impulse responses, with large bandwidth and large time­ bandwidth product. The lineae transversal filter, a delay line with weighted and summed taps, is ideally suited for the implementation of such filters because of its simplicity of gynthesis...

متن کامل

Adaptive Nonlinear Modeling for Ultrasonic Signal Processing

The purpose of this presentation is to introduce to the NDE community an empirical modeling technique which has been under development during the past thirteen years and applied particularly to many problem areas in the last five. The application of interest to today's audience is that of classification of flaw geometry from ultrasonic signals. Disciplines Materials Science and Engineering | St...

متن کامل

Digital Signal Processing System of Ultrasonic Signals

In general the ultrasonic testing is used for flaw detection and localization in tested materials. Flaws in materials are commonly characterized in measured ultrasonic signals by faults echoes. Ultrasonic signals measured on materials with coarse grained structure contain relative high level of noise. This undesirable part of ultrasonic signal should be reduced to make the fault echo detection ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of the Korean Society for Nondestructive Testing

سال: 2014

ISSN: 1225-7842

DOI: 10.7779/jksnt.2014.34.4.290